3.To view the minimum and maximum temperature select which remote sensor to read data from and then press and release the “MIN/MAX/RESET” button.
4.Pressing this button once will display the minimum temperature, minimum humidity and the date and time the data was recorded. Pressing this button a second time will display the same data for the maximum recordings.
I.MOUNTING
Note: Before permanently mounting ensure that the weather station is able to receive both the WWVB signal as well as the signal from the remote sensor. Extreme and sudden changes in temperature will decrease the accuracy of the weather station. Changes in elevation will result with inaccurate weather forecasting for the next 12 to 24 hours. These changes will require a 12 to 24 hour wait before obtaining reliable data.
A.The Weather Station
1.Mounting using the table stand
a.The indoor temperature station comes with the table stand already mounted. If you wish to use the table stand all that is required is to place the weather station in an appropriate location.
2.Mounting on the wall
a.Remove the table stand. To do this pull down on the stand from the rear and rotate forward.
b.Fix a screw (not included) into the desired wall leaving approximately 3/16” (5mm) extending from the wall.
c.Place the weather station onto the screw using the hanging hole on the backside. Gently pull the weather station down to lock into place.
19