Manually

This is only necessary if you do not wish to wait for the WWVB reception. All manual set time and date settings will be over-ridden by the reception of the WWVB signal. In most cases all that needs to be set different from the default (factory) settings is the time zone (section “D” following) and the pressure (section “K” following), which must be set to your current pressure.

PROGRAMMING SEQUENCE		Default (Factory) Setting
A.	LCD Contrast		LCD 5
B.	12/24-hour Mode		12h
C.	Hour Setting		12: AM
D.	Minute Setting		:00
E.	Time Zone Setting		-5 (EST)
F.	Daylight Saving Time ON/OFF		1 (ON)
G.	Year Setting		2000
H.	Month Setting		1 (January)
I.	Date Setting		1
J.	Degree Setting °F / °C		°F
K.	Weather Forecast Sensitivity		3
L.	Pressure Readout		rel inHg
M.	Setting the Pressure		29.91

A.SETTING THE LCD CONTRAST

1.Press and hold the “MODE/SET” button for 5 seconds or until “Lcd 5” flashes in the time Lcd.

2.There are 7 Lcd contrast levels to choose from – “Lcd 1” is the lightest and “Lcd 7” is the darkest.

3.Press the “CH/+” button to toggle through to your desired setting.

4.Press the “MODE/SET” button to confirm and advance to 12/24 hour time setting.

Manually

PROGRAMMING SEQUENCE

LCD 5

A.SETTING THE LCD CONTRAST