Quick SET-UP Guide

Hint: Use good quality Alkaline Batteries and avoid rechargeable batteries.

1.Have the projection alarm and remote temperature sensor 3 to 5 apart.

2.Batteries should be out of both units for 10 minutes.

3.Place the batteries into the remote temperature sensor first then into the projection alarm.

4.DO NOT PRESS ANY BUTTONS FOR 15 MINUTES.

In this time the display and sensor will start to talk to each other and the display will show both the indoor temperature/humidity and an outdoor temperature. If the station does not display both temperatures and indoor humidity after the 15 minutes please retry the set up as stated above. After both indoor and outdoor temperatures are displayed for 15 minutes you can place your sensor outdoors and set your time.

The remote sensor should be placed in a dry, shaded area. The remote sensor has a range of 80 feet. Any walls that the signal will have to pass through will reduce distance. An outdoor wall or window will have up to 20 feet of resistance and an interior wall will have up to 10 feet of resistance. Your distance plus resistance should not exceed 80 ft. in a straight line.

NOTE: Fog and mist will not harm your remote sensor but direct rain must be avoided.

To complete the set up of your temperature station after the 15 minutes have passed please follow the steps beginning on page 6.