III. Program Mode | La Crosse Technology WT-5120 433 instruction

III.PROGRAM MODE

To enter the Program Mode hold down the “MODE/MIN” button for 3 seconds, until the time flashes in the top of the display. The Program Mode Guide is laid out in a manner that allows you to program each function separately, or you can follow the instructions entirely to program the projection alarm. Complete programming is usually done for the initial set-up, and will require you to skip step 1 and 2 of programming sections D and E. To exit the setting mode simply wait approximately 10 seconds for the projection alarm to automatically return to normal operation.

A. PROGRAMMING SEQUENCE

1.Manual Time Display

2. Time Zone Setting

3. Daylight Saving Time On/Off

B.FUNCTION BUTTONS

There are 3 function buttons located on the front of the projection alarm and one on the top. The function buttons are labeled: AL/HOUR, light direction icon, MODE/MIN, and SNOOZE (the top bar).

Alarm Button (also adjusts		Mode Button (toggles between
	Display Direction	indoor temp/hum and alarm
the hours in time setting
		time. Also adjusts minutes in
mode)
		time setting mode

C.MANUAL TIME SETTING

1.Hold down the “MODE/MIN” button for 3 seconds, the time will flash in the Time LCD.

2.Press and release the “AL/HOUR” button to advance the hours and press and release the “MODE/MIN” button to advance the minutes.

NOTE: “A.M.” or “P.M.” will be displayed to the left of the time to help identify the time.

3.Press and release the “SNOOZE” button to confirm the time setting and to advance to DST (Daylight Saving Time) setting.

D.TIME ZONE SETTING

1.Hold down the “MODE/MIN” button for 3 seconds, the time will flash in the Time LCD.

2.Press and release the “SNOOZE” button to advance to the time zone selection.

3.In the indoor temperature/humidity section of the LCD the time zone will flash.