La Crosse Technology TX31U-IT quick setup manual Setting UP

QUICK SET UP MANUAL –

PROFESSIONAL WEATHER CENTER

Using 915MHz wireless transmission of weather data, this unique weather station can be powered using batteries for all your weather needs in the home or office.

This product offers: INSTANT TRANSMISSION is the state-of- the-art new wireless transmission technology, exclusively designed and developed by LA CROSSE TECHNOLOGY. INSTANT TRANSMISSION offers you an immediate update (every 4.5 seconds!) (every 6.5 seconds for rain!) of all your outdoor data measured from the transmitters: follow your climatic variations in real-time!

1

Rain Sensor	1)	Base and	1) 2 x Screws
(TX32U-IT)			and Plastic
		funnel
			anchors

SETTING UP:

Carefully open and check that the following contents are complete:

Item:	Consisting of:	Fittings:	Illustration:
Base Station	1) Main unit

Thermo-	1)	Main unit	1)	Wall mounting
Hygro	2)	Air Flow
				screws
Sensor		cover
			2)	Plastic anchors
(TX31U-IT)
				for screws
			3)	2 x cable ties
Wind Sensor	1)	Main unit	1)	1 x U-bolts for
(TX23U)		with wind		mast holder
		vane	2)	2 x Washers
	2)	32 ft cable	3)	2 x Nuts
		(already	4)	2 x cable ties
		attached the
		main unit)
	3)	Mast holder

2

Note:

When putting the Weather Center into operation, it is important to perform in close proximity (e.g. on a table) a complete wiring and set-up of the system. This step is important to test all components for correct function before placing and mounting them at their final destinations (See Positioning below). Spin the wind vane and tip the rain gauge to test.

1.Unwind the cables of the Wind sensor. Connect the Wind sensor to the Thermo- hygro transmitter by plugging the connector head into the socket of the Thermo- hygro sensor. The cord should “click” into place.

Wireless transmission at 915 MHz - thermo- hygro and rain sensor to the Weather Center

Rain sensor

Weather Center

Wind sensor

Sockets for wind sensor

2.	First insert the batteries into the Thermo-hygro sensor and Rain sensor (“How
	to install and replace the batteries into the Thermo-hygro sensor“ and
	“How to install and replace the batteries into the Rain sensor” below).
3.	Then insert the batteries into the Weather Center (see “How to install and
	replace the batteries into the Weather Center” below). Once the batteries are

Cable connection between the wind sensor and the thermo-hygro sensor

3

installed, all segments of the LCD will light up briefly and a short signal tone will

4