La Crosse Technology TX31U-IT LCD Contrast Setting, Manual Setting, Manual Time Setting

Low battery Indicator (weather center)	Time alarm icon
Time display		Calendar display
		Buzzer off indicator
		Wind direction display
		and wind speed in
		Beaufort scale
		Wind speed Hi
Wind Chill		alarm icon
		Wind speed or gust in
in °F or °C
Outdoor temperature		mph, km/h or m/s
or dew point		Outdoor relative
in °F or ºC		humidity in %
Outdoor temp.		Outdoor Humidity
alarm icon		alarm icon
Relative air pressure		Transmitter signal
display in inHg or
		reception icon
hPa, or total and 24h
rainfall display in inch		Weather tendency
or mm		indicator
Air pressure		Weather forecast
histogram
		icon
Low battery Indicator (Thermo-hygro)		Low battery Indicator (rain sensor)

13

Mode 2 : Wind Gust, Dew Point temperature and Rainfall reading are shown.

*When the signal from the transmitter/ or Rain sensor is successfully received by the Weather Station, this icon will be switched on. (If not successful, the icon will not be shown on the LCD). User can therefore easily see whether the last reception was successful (“ON” icon) or not (“OFF” icon). On the other hand, the short blinking of the icon shows that a reception is being done at that time.

*In normal display user may press the SET key shortly to toggle between Mode 1 and Mode 2 display:

Mode 1: Wind speed, outdoor temperature and relative pressure reading are shown.

		Wind speed icon
	In Mode 1, this
Outdoor temp	reception icon is
icon	showing the
	condition of the
	reception of the
Rel Pressure		signal from
icon	Thermo-hygro
	transmitter

14

∙	Storm warning threshold value
∙	Storm alarm On/ Off setting

Dew point icon

Rainfall icon

Wind gust icon

In Mode 2, this reception icon is showing the condition of the reception of the signal from Rain sensor

LCD CONTRAST SETTING

Flashing

The LCD contrast can be set within 8 levels, from "LCD 1" to "LCD 8" (default setting is LCD 5):

1.Press the SET key, the contrast level digit will start flashing.

2.Use the + or MIN/MAX key to adjust the level of contrast.

3.Confirm with the SET key and enter the MANUAL TIME SETTING.

MANUAL SETTING:

The following manual settings can be changed once the SET key is pressed and hold for about 2 seconds:

∙LCD contrast setting

∙Manual time setting

∙12/24 hour time display

∙Calendar setting

∙°F/ °C temperature unit setting

∙Wind speed unit

∙Rainfall unit setting

∙Air pressure unit setting

∙Relative pressure reference value setting

∙Weather tendency threshold value

15

MANUAL TIME SETTING:

You then may manually set the time of the clock by following the steps below:

Minutes flashing

Hour flashing

1.The hour digit will start flashing.

2.Use the + or MIN/MAX key to set the hour.

3.Press the SET key to switch to the minutes. The minute digit will start flashing.

4.Use the + or MIN/MAX key to set the minute.

5.Confirm the time with the SET key and enter the 12/24 HOUR TIME DISPLAY SETTING.

16