La Crosse Technology WS-9046U II. the Remote Wind Speed Sensor, Mounting with the U-SHAPED Bolt

Page 16

II.THE REMOTE WIND SPEED SENSOR

The remote wind speed sensor can be mounted two ways:

•With the use of screws

•Using nylon straps

•Using the U-shaped bolt

A.MOUNTING WITH SCREWS

1)Unlock the mounting bracket from the remote wind speed sensor leaving the wire going through the bracket.

2)Place the mounting bracket over the desired location.

3)Through the two screw holes of the bracket, mark the mounting surface with a pencil.

4)Screw the mounting bracket onto the mounting surface. Ensure that the screws are tight against the bracket.

5)Slide the remote wind speed sensor onto the bracket making sure to lock it in place.

B.MOUNTING WITH NYLON STRAPS

1)Unlock the mounting bracket from the remote wind speed sensor leaving the wire going through the bracket.

2)Place two nylon straps through the slots on the mounting bracket.

3)Place the remote wind speed sensor in your desired location.

4)Fasten the two nylon straps securely around the mounting location.

5)Slide the remote wind speed sensor onto the bracket making sure to lock it in place.

C.MOUNTING WITH THE U-SHAPED BOLT

1)Use the U-shaped bolt provided and thread it through each of the holder holes.

2)Fix the holder to a mast by using the nuts provided.

III. THE RAIN SENSOR (OPTIONAL)

1.Securely mount the rain sensor onto a horizontal surface about 2-3 ft above the ground and in an open area away from trees or other coverings. (Rainfall may be reduced causing inaccurate readings.)

2.When securing into place, check that rain excess will not collect and store at the base of the unit but can flow out between the base and the mounting surface (test by pouring clean water).

3.After mounting the rain sensor, connect the cable to the thermo-hydro sensor at the corresponding socket so power supply can be received and data be transmitted to the base station.

Note: For testing purposes, very slowly pour a small amount of water into the rain sensor funnel. This simulates the rainfall and rainfall reading will be received and displayed at the base station for about 2 minute delay. (To clear this data on the base station, refer to the resetting data section in “Rainfall Measurement”)

15

Page 15 Page 17
Image 16
Page 15 Page 17
Contents WS-9046U Table of Contents Inventory of Contents Optional Sensor Purchase SeperatelyAdditional Equipment not included About Wwvb Radio Controlled TimeQuick SET-UP Guide Important Notes on Set-up and OperationDetailed SET-UP Guide Battery Installation Remote TEMPERATURE/HUMIDITYProgram Mode Programming Sequence and Default SettingsIII. Setting the LCD Contrast IV. Time Zone SettingDaylight Saving Time DST Setting II. Function KeysVIII. Time Setting Wwvb Remote Control TimeManual Time Setting IX. Setting the YEAR, DAY and MonthSetting the Snooze Setting the Unit of Rainfall inch/ mmXiii Setting the Forecast Sensitivity Selecting F or CWeather Forecast Features of the WS-9046UWeather Icons III. Outdoor Temperature and Humidity IV. Minimum and Maximum Temperature RecordsViewing the Indoor Temperature Records Viewing the Outdoor Temperature RecordsMoon Phase VI. Viewing the CURRENT, Maximum and Minumum DEW PointVIII. Beaufort Scale Wind Speed Fort Number Or Force Wind Speed Mph Km/hr KnotsIX. Rainfall Measurement To reset the maximum rainfall measurements To return to the normal viewing modeTime Alarm To view the current rainfall measurementsMounting Remote TEMPERATURE/HUMIDITY Sensor Mounting with ScrewsMounting with Adhesive Tape Mounting with Nylon StrapsMounting with the U-SHAPED Bolt II. the Remote Wind Speed SensorIII. the Rain Sensor Optional Maintenance and Care Instructions TroubleshootingIII. the Indoor Weather Station Specifications Power SupplyDimensions H x W x D Weather data measuring rangeFCC Disclaimer
Top Page Image Contents