Hitachi 240353 manual Accessory Fluid Filter Kit

Accessory Fluid Filter Kit

Fluid Filter Kit 240–440

Ref.	Part No.	Description	Qty.
No.
101	114–361	FILTER, fluid	1
102	113–322	CONNECTOR, male	1
103	054–188	TUBE; PTFE;R3/8” O.D.	8 in.
104	113–534 ELBOW, male x female		2
105	111–917	NIPPLE; Nylon	1

The Fluid Filter Kit, listed above, can be installed to filter fluid drawn by the suction tube after it comes out of the pump. Install the Fluid Filter Kit as follows (see Fig. 3):

1.Apply thread sealant (specified in Fig. 3) to all male threads in this kit.

2.Remove the elbow (40) from the pump outlet, and remove the tube (16). See the Parts drawing on page 11.

3.Thread one the elbows (104) into the pump outlet.

4.Assemble the nipple (105) and the other elbow (104)

5.Thread the nipple (105), with the elbow (104) attached to it, into the elbow (104) that you threaded into the pump outlet.

6.Thread the fluid filter (101) onto the male threads of the elbow (104).

7.Thread the male connector (102) into the fluid filter (101).

8.Turn the fluid filter/male connector assembly towards the elbow (39). This makes connecting the tube (103) in step 9 easier.

9.Cut the PTFERtube (103) to the proper length, and install it to run from the male connector (102) to the elbow (39).

{To avoid sharp bends in the tube, you may have to cut it to a shorter length.

}Apply Graco Thread Sealer, or LoctiteR 567, or equiv- alent to male threads.

YFor initial installation, make sure the dome is firmly hand tightened onto the filter body. Do not use a tool. During subsequent service, hand tighten more firmly to prevent drips.

39

103{

103}

102}

101Y 104}

105}

104}

Fig. 3 8157A

14 308-845