Digital Tuner, Tuning to Radio Stations | Philips AZ1040 instruction

DIGITAL TUNER

1.Select TUNER source.

™ is displayed briefly and then the radio station frequency is shown.

2.Press BAND once or more to select your waveband.

3.Press SEARCH ∞ or § and release when the frequency in the display changes.

™The radio automatically tunes to a station of sufficient

reception. Display shows

during automatic tuning.

™If a FM station is received in stereo, STEREO is shown.

4.Repeat step 3 if necessary until you find the desired station.

• To tune to a weak station, press SEARCH ∞ or § briefly and repeatedly until you have found optimal reception.

5.Adjust the power slider to TAPE/OFF position to switch off the set.

MODE

–For FM, pull out the telescopic antenna. Incline and turn the antenna. Reduce its length if the signal is too strong (very close to a transmitter).

–For AM, the set is provided with a built-in antenna so the telescopic antenna is not needed. Direct the antenna by turning the whole set.

You can store up to a total of 30 radio stations in the memory.

1.Tune to your desired station (see Tuning to radio stations).

2.Press PROG to activate programming.

– Display: PROGRAM flashes.

3.Press PRESET 4 or 3 once or more to allocate a number from 1 to 30 to this station.

4.Press PROG again to confirm the setting.

–Display: PROGRAM disappears, the preset number and the frequency of the preset station are shown.

5.Repeat the above four steps to store other stations.

– You can overwrite a preset station by storing another frequency in its place.

Press PRESET 4 or 3 until the desired preset station is displayed.

SHUFFLE

ALL