1 Important
Read and understand all instructions before you use this product. If damage is caused by failure to follow the instructions, the warranty does not apply.
Important notes for users in the U.K.
Mains fuse
This information applies only to products with a UK mains plug.
This product is fitted with an approved non- molded plug. If you replace the fuse, use one with:
•the ratings shown on the plug,
•a BS 1362 approval, and
•the ASTA approval mark.
Contact your dealer if you are not sure about what type of fuse to use.
Caution:To conform with the EMC directive (2004/108/EC), do not detach the plug from the power cord.
How to connect a plug
The wires in the power cord are colored as follows: blue = neutral (N), brown = live (L).
If the colors do not correspond with the colors on your plug, identify the terminals in your plug as follows:
1
2
3 Do not connect either wire to the earth terminal in the plug, marked E (or e) or colored green (or green and yellow).
Before you replace the plug cover, make sure that the cord grip is clamped over the sheath of the cable and not just over the two wires in the cable.
Safety
Risk of electric shock!
•Never expose the product and accessories to rain or water. Never place liquid containers, such as vases, near the product. If liquids are split on or into the product, disconnect it from the power outlet immediately. Contact Philips Consumer Care to have the product checked before use.
•Never place the product and accessories near naked flames or other heat sources, including direct sunlight.
•Never insert objects into the ventilation slots or other openings on the product.
•Where the mains plug or an appliance coupler is used as the disconnect device, it shall remain readily operable.
•Disconnect the product from the power outlet before lightning storms.
•When you disconnect the power cord, always pull the plug, never the cable.
Risk of short circuit or fire!
•Before you connect the product to the power outlet, make sure that the power voltage matches the value printed on the back of the product.
•Avoid applying pressure on the power plugs. Loose power plugs can cause arcing or fire.
Risk of injury or damage to the product!
•To avoid exposure to laser radiation, do not disassemble.
•Do not touch the optical lens inside the disc compartment.
•Never place the product or any objects on power cords or on other electrical equipment.
•If the product is transported in temperatures below 5°C, unpack the product and wait until its temperature matches room temperature before connecting it to the power outlet.
2EN