OPERATING INSTRUCTIONS
NORMAL PLAYBACK
NOTE: This player can play all normal CD's plus
1.Connect the headphones to the PHONES jack. Set the VOLUME control to a low level before you begin playback and then adjust the volume to a
comfortable level after playback begins.
To PHONES Jack 
2.Slide the CD Door OPEN switch to the right to release the lock and open the CD Door.
3.Place your disc on the center spindle with the printed label side facing up. Press down gently near the center hole to make sure the disc is properly seated on the spindle.
4.Close the door completely until it locks shut.
5.Press the PLAY/PAUSE 
button. “45 sec” followed by “00” appear in the display as the player reads the disc. The total tracks and playing time will appear momentarily and then playback begins on Track 1. The
6.Adjust the VOLUME and DBBS (Bass Boost) controls as desired.
7.When all tracks have been played the player stops and the display again shows the total tracks and playing time on the disc. After approximately 30 seconds the power shuts off and the display goes blank.
To stop playback before the disc ends press the STOP 
button at any time. Press the STOP 
button again to shut the power off immediately.
ON | OFF |
VOL. |
|
7
HD2700_ib.p65 | 7 | 21/11/2001, 15:46 |