Panasonic SA-HE75 Select the input, Output the signal, Adjust the level, Stop the test signal

Change the settings to suit your speakers and units to the environment in which you are using them. Before making any changes,read the descriptions of the settings, note the factory settings and ranges, and refer to the equipment’s instructions.

3 FILTER	4	D-INPUT	5	Adjusting speaker output
		Digital input		level

Change the cut-off for bass output from the front speakers

If you set the front speakers to “SMALL”, the filter is set to 100 Hz. Raise the cut-off if the bass from the front speakers is unsatisfactory so the bass is output through the subwoofer.

You can raise the cut-off from 100 Hz to either 150 Hz or 200 Hz.

Change these settings to suit the connections you have made to the three digital input terminals, COAX, OPT 1 and OPT 2, so that the correct source is selected when you turn [INPUT SELECTOR].

The factory settings are:

CD:	COAX
DVD:	OPT 2
TV:	OPT 1

Adjust the level of the other speakers based on the output of the front speakers. (Adjust the volume of the front speakers with [VOLUME].)

C (center), SR (surround right), and SL (surround left) can be adjusted between –10 dB and +10 dB, with 0 being the level of the front speakers.

Adjust center and surround output to the same apparent level of the front speakers.

For SW (subwoofer), you can select “---” so there is no output, “MIN” for minimum output, a level between 1 and 19, or “MAX” for maximum output.

Adjust subwoofer output so it is balanced with the front speakers. Subwoofer output is easily influenced by the source. You can also change its level while playing something for better effect (\ page 13).

Preparation: Turn SPEAKERS on.

TEST

Select.Select.

– VOLUME +

Select the input.

LEVEL

	Repeat.
Change the setting.	Change the setting.

– +

Repeat these steps for each input.

TEST

Output the signal.

							3
	Two seconds each.						Step
L		C	R	SR	SL	SW
Speakers set as “NONE” or “NO”
are skipped.

Adjust the main volume.

Select the speaker channel.

Repeat.

Adjust the level.

Repeat these steps for each speaker channel.

Stop the test signal.	RQT6847
	9