Emerson iC200 owner manual IC200NCab050307.p65 2007

2.) Select the correct adapter for your particular iPod® model from among the 5 different adapters included. Each adapter is engraved with the name and/or size of an iPod® model. Place the selected adapter in the docking area so that the iPod® 30-pin connector passes through the opening in the adapter.

Gently press downward on the adapter until it “clicks” and locks in place.

3.) Mount the iPod® Support Bracket on the docking station as shown.

This bracket provides support and prevents your iPod® from moving too far backward when you operate the iPod® controls.

CAUTION: You must use this support bracket with all iPod® models to prevent possible damage to the iPod® connector.

NOTE: If you are using either the 30GB or 60GB fifth generation iPod® models with video capability or the 2G (Second Generation) iPod® nano, use the adapters that were supplied with the iPod® at time of purchase. They will fit correctly in the docking cradle of this system.

IMPORTANT

• If you are using a “1G (First Generation) iPod® nano” you will notice that the iPod® 30-pin connector on this unit is not properly aligned with the opening in the iPod® nano adapter.

• Before inserting the iPod® nano adapter into the docking area you must slide the iPod® 30-pin connector to the left position, and then place the nano adapter into the docking area.

27

iC200_NCab050307.p65 27

3/5/2007, 11:29