Emerson CKT9100 owner manual Installing The Telephone Memory Back-up Battery

Page 8

Installing The Telephone Memory Back-up Battery

This unit requires a 9-Volt battery, not included, to maintain the telephone caller ID and speed-dial number memories in the event of a temporary power interruption. Be sure to use a well-known brand of alkaline battery for longest life and best performance. If you do not install the back up battery, any numbers that you have entered into the speed dialing memories, and numbers that have been automatically recorded in the caller ID memories, may be erased if the AC power supply is interrupted.

Install the telephone memory back-up battery as follows:

1.) Turn the telephone base unit upside-down. To prevent scratches to the base unit, place it on a soft surface such as a towel or blanket as you perform this procedure.

SLIDE

TO OPEN

2.) Press down on the engraved “arrow” on the battery compartment door and slide the door in the direction of the arrow to remove it.

3.) Attach the 9-volt battery to the terminals of the battery harness as shown.

It can only be attached one way.

4.) Push the battery back into the battery compartment and replace the battery door. Turn the base unit right side up again.

7

CKT9100_090606.p65

7

6/9/2006, 11:00

Image 8

Contents CKT9100 Important Safety Instructions CKT9100090606.p65 2006 CKT9100090606.p65 2006 IM Portant Notes FCC InformationFCC wants you to know Ringer Equivalence Number RENPreparation for USE Unpacking and SET-UPInstalling The Telephone Memory Back-up Battery Install the telephone memory back-up battery as followsLine Cord Low Battery IndicationConnecting The Telephone Cords Disconnecting The Telephone Cords Coiled Handset CordPower Source Protect Your FurnitureLocatio N of Contro LS and I Ndicators TOP Panel Telephone Handset Telephone LCD Display Call Waiting and Caller ID Service Information Telephone Operating InstructionsCaller ID Display Set-up and Adjustments CKT9100090606.p65 2006 Other Adjustments Handset Volume LevelTelephone Ringer Level TONE/PULSE Dialing SelectorCaller ID Display Viewing Angle Storing Numbers In The Handset Memory To store numbersReceiving Calls Call WaitingMaking Calls Last Number Redial MemoryCaller ID Operation CKT9100090606.p65 2006 To Delete All Numbers From The Caller ID Memory To Dial a Number Stored In Caller ID MemoryTo Delete a Number from The Caller ID Memory Setting the TIME, the First Time Clock Radio Operati NG I Nstructi ONSYear Display Daylight Saving and Leap Year AdjustmentsDate Display Manual Time Adjustments Adjusting the Wake UP TimesSelecting the Alarm Mode Checking the Wake UP Times and Alarm ModeListening to the Radio Antenna InformationWake to Radio Radio and Buzzer Operation Snooze AlarmWake to Buzzer Sleep to Music Timer Dimmer ControlChanging the Lithium Battery Be Careful not to Lose this Small ScrewBattery holder slot Turn the holder up side down Resetting the Clock After a Total Memory Loss Important Note Care and M Aintenance Limited Warranty CKT9100-090606-02