NOTES:
A.) The clock radio must be at room temperature for the WAVE SENSOR to function properly. If the radio has been in a cold location the WAVE SENSOR may not operate immediately. Place the radio in the room where it will be used, connect it to the AC outlet, and allow approximately 30 minutes to 60 minutes for the radio to come to room temperature before testing the WAVE SENSOR function.
B.) If the DIMMER switch is set to the “OFF/WAVE” position the display will be completely ‘Off’. However at the Alarm time the display will return to full brightness automatically. It will remain at full brightness for one hour and then return to the ‘Off’position. If you stop the alarm immediately by pressing the respective Alarm 1 or Alarm 2 buttons, or set the Alarm 1 or Alarm 2 switches to their “OFF” positions, or use the SNOOZE control, the display will return to the ‘Off’position after 10 seconds.
20
CKS3088_072106.p65 | 20 |