Emerson CKA1100 owner manual Listening to the Radio, Antenna Information

Page 15

LISTENING TO THE RADIO

1.) Set the BAND selector to either the AM or FM position.

2.) Press the RADIO ON/OFF button to turn the radio ‘On’. The LED dial pointer comes ‘On’.

3.) Turn the TUNING control to tune to the desired station.

4.) Adjust the VOLUME control to the desired level.

5.) When you are finished listening press the RADIO ON/OFF button to turn the radio ‘Off’. The LED dial pointer goes ‘Off’.

Antenna Information

FM

The FM antenna is built in to the AC power cord. Be sure the power cord is completely unwound and extended to its full length for best FM reception.

AM

The AM ferrite bar antenna is located inside the radio cabinet. If AM reception is unsatisfactory you may have to change the position of the cabinet until the internal AM antenna picks up the strongest signal.

14

CKA1100_drafts052102.p6514

21/5/2002, 15:19

Image 15
Contents Jumbo Display Important Safety Instructions Thank you FCC Information Important NotesPower Source Preparation for USEUnpacking and SET-UP To install or replace the batteries Battery BACK-UP SystemTop Panel Front Panel Location of Controls and IndicatorsOperating Instructions Important Information about the Atomic Clock Time SignalCKA1100drafts052102.p658 21/5/2002 Information about the Wwvb Signal Receiver in CKA1100 Positioning The External Wwvb Antenna Setting the Clock the First TimeAutomatic Time Setting Location, Location, LocationFailure To Receive The Wwvb Signal Manual Time Setting Setting the Wake UP Times Automatic Time SynchronizationSeconds Counter Antenna Information Listening to the RadioSnooze / Repeat Alarm Alarm OperationDisplay Dimmer Control Sleep to Music TimerCare and Maintenance Emerson Radio Corp Limited Warranty Emerson