Emerson CKA1100 owner manual Preparation for USE, Unpacking and SET-UP, Power Source

Page 5
AC Plug
AC Outlet

PREPARATION FOR USE

UNPACKING AND SET-UP

•Remove the radio and the external WWVB long wave antenna from the carton and remove all packing materials from the radio. Please save the carton and packing materials if possible in the unlikely event that the radio ever needs to be returned for service. Using the original carton and packing materials is the only way to pack the radio safely to avoid damage in transit.

•Remove any descriptive stickers or labels from the front or top of the cabinet. Do not remove any labels from the back or bottom of the cabinet.

•Extend the AC power cord to its full length.

Note: The FM Antenna is built into the AC power cord.

•Extend the wire of the external WWVB long wave antenna to its full length. Insert the plug from the antenna wire into the antenna jack on the back of the radio.

BACK PANEL

POWER SOURCE

This radio is designed to operate on normal 120V 60Hz AC power only. Do not attempt to operate the radio on any other power source. You could cause damage to the radio that is not covered by your warranty.

This radio should be connected to an AC outlet that is always ‘live’. Do not connect it to an outlet that is controlled by a wall switch. When the power to the radio is interrupted, the back up battery take over to maintain the time and alarm settings. To maximize the life of the battery keep the radio connected to a ‘live’AC outlet at all times.

You will note that this system is equipped with a polarized AC power

plug having one blade wider than the other. This is a safety feature. If this

plug does not fit into your existing AC

outlet, do not try to defeat this safety feature by filing the wide blade to

make it fit into your outlet. If this plug will not fit into your outlet, you probably have an out-dated non-polarized AC outlet. You should have your outlet changed by a qualified licensed electrician.

4

CKA1100_drafts052102.p654

21/5/2002, 15:19

Page 4 Page 6
Image 5
Page 4 Page 6
Contents Jumbo Display Important Safety Instructions Thank you FCC Information Important NotesUnpacking and SET-UP Power SourcePreparation for USE To install or replace the batteries Battery BACK-UP SystemTop Panel Front Panel Location of Controls and IndicatorsOperating Instructions Important Information about the Atomic Clock Time SignalCKA1100drafts052102.p658 21/5/2002 Information about the Wwvb Signal Receiver in CKA1100 Automatic Time Setting Setting the Clock the First TimeLocation, Location, Location Positioning The External Wwvb AntennaFailure To Receive The Wwvb Signal Manual Time Setting Seconds Counter Setting the Wake UP TimesAutomatic Time Synchronization Antenna Information Listening to the RadioSnooze / Repeat Alarm Alarm OperationDisplay Dimmer Control Sleep to Music TimerCare and Maintenance Emerson Radio Corp Limited Warranty Emerson
Top Page Image Contents