Setting The Time (Clock)
When the batteries are first installed the buzzer will beep twice, the display turns ‘On’and shows “12:00”.
1.) While the display shows “12:00” press the S button once. The Hour digits begin to flash.
2.) If you are setting the time to PM, press the OFF/RESET button once. The PM indicator appears. If you are setting the time to AM, skip this step and proceed to Step 3.
Repeatedly pressing the OFF/RESET button while the hour digits are flashing switches the display between the AM mode (PM indicator ‘Off’) and PM mode (PM indicator ‘On’)
3.) While the hour digits are flashing enter the correct hour by pressing the respective number keys.
Note: You must enter two digits for the hour display. For example if the hour is 2:00 press the “0” button first and then the “2” button. When the desired hour appears on the display press the S button again. The hour digits stop flashing and the minute digits begin to flash.
4.) Use the number buttons to enter the correct minute and press the S button again. The minute digits stop flashing and the clock begins to run.
PM
PM
Setting The Timer/Radio Operation
The 99 minute timer allows you to play the radio for between 1 minute and 99 minutes and then the radio stops, the buzzer alarm sounds for 90 seconds, and the power shuts ‘Off’automatically.
1.) If the display is showing the time, press the CLOCK/TIMER button once to change to the Timer display “00:00”. Repeatedly pressing the CLOCK/TIMER button switches the display between the Clock and Timer modes.
2.) While the display is in the Timer mode “00:00”press the appropriate number buttons to enter the number of minutes you wish the radio to play before shutting off automatically.
Note: You can only enter whole minutes from “1” to “99”. You cannot enter seconds.
3.) When the desired number of minutes appears on the display press the START button to turn the radio ‘On’. The RADIO ON indicator appears in the display.
4.) Set the AM/FM band switch to the desired band.
5.) Rotate the TUNING knob to tune in the desired station.
6.) Rotate the VOLUME control to adjust the volume level.
7.) When the timer counts down to “00:00” the radio stops, the display lighting comes ‘On’, the electronic buzzer sounds for 90 seconds, and then the power shuts ‘Off’automatically.
8.) To shut the radio ‘Off’manually and cancel the timer operation, press the OFF/RESET button at any time. The radio shuts ‘Off’and the timer is reset to “00:00”. To view current time, press the CLOCK/TIMER button.
Antenna Information
AM – The AM antenna is inside the cabinet. If AM reception is unsatisfactory slowly rotate the unit until you find the position that provides the best reception.
FM – Make sure the external FM wire antenna is extended to its full length. It may be necessary to vary the position and direction of this antenna until you find the position that provides the best reception.
Care And Maintenance
If the cabinet becomes dusty or dirty it may be wiped with a soft cloth slightly moistened with a mild soap and water solution. Do not use any abrasive cleaners or cleaning pads to avoid scratching the cabinet.
When the sound becomes weak or distorted, and the performance becomes unsatisfactory, replace the batteries as soon as possible. Never leave weak or exhausted batteries in the radio for an extended period of time.
FCC Information
This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions:
(1)This device may not cause harmful interference, and
(2)This device must accept any interference received, including interference that may cause undesired operation.
LIMITED WARRANTY
Emerson Radio Corp. warrants manufacturing defects in original material, including original parts and workmanship, under normal use and conditions, for a period of ninety (90) days from the date of original purchase in the U.S. With your dated proof of purchase, we will provide repair service at no charge for labor and parts at an authorized Depot Repair Facility, or replace the product in our discretion. For repair or replacement, pack your unit in a padded box, enclose your check or money order payable to Emerson Radio Corp. in the amount of $5.00 (not required by California residents) to cover shipping and handling costs, and enclose a copy of your proof of purchase. Send your unit to:
Emerson Radio Corp.,
5101 Statesman Drive,
Irving, TX 75063.
This warranty does not cover damage from negligence, misuse, abuse, accident, failure to follow operating instructions, commercial use, rental, repairs by an unauthorized facility, or products purchased, used, serviced or damaged outside of the United States.
THIS WARRANTY GIVES YOU SPECIFIC LEGAL RIGHTS, AND YOU MAY ALSO HAVE OTHER RIGHTS WHICH VARY FROM STATE TO STATE.
AU898H
Part | Printed in China |