Checking or Cancelling Timer Recordings | Philips VRB664AT specification

Timer Recording (cont’d) 37

Checking or Cancelling Timer Recordings

1

With the VCR on and in VCR position (the VCR light will appear on the display panel), press the VCR button, then press the

MENU button.

POWER

VCR/TVSPEED

REC/OTR

2-4

EJECT

MEMORY

PAUSE/STILL

2

Press the PLAY/o button or the STOP/p button to select

PROGRAM, then press the F.FWD/B button.

31

Press the PLAY/o button or the STOP/p button to select PROGRAM REVIEW, then press the F.FWD/B button. The timer recording information for the program in the lowest numbered slot will appear on the screen. If no timer recordings are set, nothing will happen when you press the F.FWD/B button.

4

Press the F.FWD/B button repeatedly to review all pro- grammed timer recordings. If you don’t press the F.FWD/B button within 10 seconds, the VCR will automatically display infor- mation about the next programmed timer recording. This will continue until all timer recordings have been displayed. Then the menu will disappear.

	PLAY
REW	F.FWD
	STOP

				5
MENU	STATUS/EXIT	CLEAR

1 2 3

CH.

4 5 6

7 8 9

MUTE	0	ALT.CH	VOL.
			VOL.
VCR	TV	CBL/DBS
		VCR PLUS+
VAR.SLOW		/ENTER	SLOW
TRACKING		F.ADV	X2 PLAY
SMART	TIME	INDEX REC END	SKIP
PICTURE	TIME	INDEX REC END	SKIP

SEARCH

5

To cancel the timer recording displayed, press the CLEAR button. Either the display will disappear or information about other timer recordings will appear. If you do not press any other buttons, the display will disappear after all timer recordings have been displayed.

6

Repeat steps 1 - 4 to make sure you have cleared the cor- rect timer recording.

Helpful Hints

•CLASH may flash on the screen when you finish setting a timer recording. This means that the timer recording you just programmed and another timer recording overlap. The current timer recording will not take place. You may choose to cancel the overlapping timer recording.

•To stop a started timer recording, press the STOP/EJECT button on the VCR.

•With ShowGuard, if the power fails for more than one minute, pro- grammed timer recordings will be restored when the clock is reset. Details are on page 58.

Image 37

Philips VRB664AT owner manual Checking or Cancelling Timer Recordings, Menu button

Contents

VRB664AT For Customer Use Dear Philips product owner Introduction FeaturesDeclaration of Conformity Table of Contents Using the Remote Control Putting Batteries in the Remote ControlVCR maintenance Removing the Plastic Cover from the Front Panel Disconnect the antenna or cable from your TV Hookups Without a Cable Box/Direct Broadcast System Plug in the TV and the VCR Hookups Without a Cable Box/Direct Broadcast System cont’d Connections Hookups With a Cable Box/Direct Broadcast SystemRecording/Viewing Any Channel Recording One Channel/Watching Another Hookups With a Cable Box/Direct Broadcast System cont’d Hookups With a Stereo TV Press the Menu button. The display shown below will appear Turning on Your VCR Press the VCR button Press the Menu button Automatic Channel Setup Adding/Deleting Channels Automatic Channel Setup cont’d Press the STATUS/EXIT button once or twice to exit Reviewing Memorized Channels Do each step within 60 seconds of the previous step Manual Clock SettingInstructions continue on Enter a 0 before a single-digit number Setting the Clock cont’d Press the VCR button, then press the Menu button Automatic Clock Setting Time Zone Daylight-Savings Time Language Selection Setting the Remote to Operate a TV Cable BOX Codes Remote Control Buttons Remote Control Buttons cont’d RECord/OTR Button REWind/ ButtonMenu Button Number Buttons Status Display example only On-Screen Status DisplaysIf you select Status ON, then select Counter only on If you select Status ON, then select Counter only OFF VCR Display Panel Front Panel Rear Panel VHS Quasi Play Back Sqpb Playing Turn on the TV and set it to channel 3 or 4, whichever chan Recording OTR CH12 One-Touch Recording Recording One Channel/Watching Another Daily Timer Recording Timer Recording cont’d Press the STATUS/EXIT button. Program WAS COM Timer Recording cont’dTape Speeds Checking or Cancelling Timer Recordings Channels Setting Up the VCR Plus+ Programming System Setting Up the VCR Plus+ Programming System cont’d Timer Recording with the VCR Plus+ Programming System See page 58 for more hints Set the clock. Details are on pages Auto DBS RecordLink RF coaxial cable Rerecording Tape Duplication Press the PLAY/o button or the STOP/p button to select Repeat PlayPress the F.FWD/B button so that on appears beside Automatic Operation Features Forward and Reverse Searching SP/LP/SLP Special Effects PlaybackSuper High Speed Searching LP/SLP Playing a Tape at Double Speed Viewing a Slow Motion Picture Viewing a Still PictureDuring tape playback, press the PAUSE/STILL button. a Child Lock When Child Lock is activated Smart Picture Press the VCR button Press the Time Search button Time Search Press the VCR button Press the Index Search button Example Skip Search Record End Search Real-Time Counter Memory Blue Background Understanding On-Screen Displays Multi-Channel Television Sound System Multi-Channel Television Sound System cont’d Please see additional notes on Hi-Fi Stereo Sound System Helpful Hints Helpful Hints cont’d Cable Box/DBS Output Channel 03 or Glossary Specifications Video Cassette Recorder or Player Limited Warranty To obtain a replacement product from Philips Limited Warranty cont’dPayment Amount Payment, if applicable Automatic IndexPage Page Page Supplied Accessories