OPERATION
PRE-OPERATION PROCEDURES
CHECK POWER SOURCE
1.Using a calibrated flowmeter and pressure gauge, check that the hydraulic power source develops a flow of
2.Make certain that the hydraulic power source is equipped with a relief valve set to open at
3.Check that the hydraulic circuit matches the tool for
CHECK THE TOOL
1.Make certain all tool accessories are correctly in- stalled. Failure to install tool accessories properly can result in damage to the tool or personal injury.
2.There should be no signs of leaks.
3.The tool should be clean and dry with all fittings and fasteners tight.
CONNECT HOSES
1.Wipe all hose couplers with a clean
2.Connect the hoses from the hydraulic power source to the tool fittings or quick disconnects. Connect the return hose first and disconnect it last to eliminate or reduce trapped pressure for easier
NOTE:
If uncoupled hoses are left in the sun, pressure in- crease within the hoses can make them difficult to connect. Whenever possible, connect the free ends of hoses together.
3.Observe the flow indicators stamped on the hose couplers to ensure that the flow is in the proper di- rection. The female coupler on the tool’s IN port is the inlet coupler. See illustration in back of this man- ual for tool port identification.
4.Squeeze the drill trigger momentarily. If the drill does not operate, the hoses might be reversed. Verify correct connection of the hoses before continuing.
DETERMINE TOOL MODEL
Open-center or Closed-center Models
If you are in doubt about the type, test the tool by con- necting it to an
10 ► HD01 User Manual
ger released than when the trigger is pulled, the tool is
Open-center/Closed-center Selectable Models
The
IMPORTANT
Failure to set this spool correctly can cause a
mismatch with the hydraulic circuit. This can result in rapid tool heating, seal failure, and poor tool performance.
NOTE:
All models have a knurled knob on the spool. This knob cannot be rotated on
CONTROLS
FORWARD/REVERSE
Forward/Reverse rotation is selected by the lever on the
Figure 2. Operator Controls
A |
|
| |
B |
|
| |
Function Select - Hammer |
|
| |
Only, Drill Only or Combine |
|
| |
Hammer and Drill. Press mode |
|
| |
selector button (B) and turn the |
|
| |
mode selector (A). |
| C | |
|
| ||
FWD | C | C | |
REV | |||
|
| ||
| |||
Forward and Reverse | |||
Select |
| Select |