Friedrich PACKAGED TERMINAL AIR CONDITIONERS AND HEAT PUMPS manual Additional Accessories

New Construction Accessories (Continued)

MODEL NUMBER	DESCRIPTION		PHOTO
	DESK CONTROL KIT A field installed kit which
PXDC	allows the unit to be turned on or off from a remote
	central station via a 24V interface. This kit is
	compatable with all chassis models.
			PXDC
RT1	DIGITAL REMOTE THERMOSTAT	A Honeywell
	wall mounted remote thermostat. Compatable only			RT1
	with "RT" suffix chassis.
Additional Accessories
MODEL NUMBER	DESCRIPTION		PHOTO
	SLEEVE EXTENSION RETROFIT KIT G-90 zinc
	coated steel, 2¼" sleeve extension attached to the
PXSE	room side of the sleeve to allow for the installation
	of a P-Series Friedrich PTAC in a T-Series sleeve.
			PXSE
	LATERAL DUCT ADAPTER Attaches to the PTAC/
	PTHP unit and provides a transition to direct up to
PXDA	35% of the total CFM to a secondary room, either
	left or right of the unit. Kit includes duct plenum
	with discharge grille and internal baffle, adapter and
	end cap.
	LATERAL DUCT EXTENSION	A three foot
	insulated plenum that attaches to the left or right		PXDA
	side of the duct adapter. The extension can be cut
PXDE
	to length by the installer. Maximum allowable
	straight extension is fifteen feet.
	REPLACEMENT FILTER PACK These are original
	equipment return air filters. They are reusable and
PXFT	can be cleaned by vacuuming, washing, or blowing
	out, and are sold in convenient ten packs. (Two
	filters per chassis).		PXFT
Chassis Options
ITEM	DESCRIPTION
S	STANDARD UNIT Standard PTAC/PCHP chassis. Can be 230/208V or 265V, electric
	or heat pump.
R	REMOTE THERMOSTAT Chassis option necessary for wall mounted thermostat
	control of the unit.
	SEACOAST PROTECTION Additional protection for PTAC/PTHP units in a coastal or
C	corrosive environment. The entire outdoor coil is submerged in a specially formulated
	enamel coating, then oven-cured for a tough, corrosion-resistant finish.

9