The radio
|
|
| AV SYSTEM | TV | VCR/AUX |
|
|
| SLEEP | TV/VIDEO TUNER/BAND | DVD/CD | TUNER/BAND | |
|
| FL DISPLAY |
|
|
| |
|
|
|
|
|
| |
|
| DIMMER |
|
|
|
|
|
|
| 1 | 2 | 3 |
|
|
| PLAY MODE |
|
|
|
|
|
| MIX 2CH |
|
|
|
|
|
|
| 4 | 5 | 6 | Numbered |
|
| REPEAT |
|
|
| |
|
|
|
|
| buttons | |
|
|
| 7 | 8 | 9 | |
|
| POSITION | CANCEL | =>10/ENTER |
| |
|
| MEMORY |
| |||
| SKIP |
|
| 0 |
|
|
| SKIP | SLOW/SEARCH | SLOW/SEARCH | |||
| u i | CH |
|
| ||
| 2 CH 1 |
|
| t y | ||
|
|
|
|
| ||
|
| TOP MENU |
|
| MENU |
|
|
| DIRECT |
|
| PLAY LIST |
|
|
| NAVIGATOR |
|
|
|
|
| ENTER |
| ENTER |
|
| |
|
| DISPLAY |
|
| RETURN |
|
|
| TV VOL |
|
| TV VOL |
|
|
|
| VOLUME |
| VOLUME | |
|
|
|
|
|
| |
operations |
| MUTING | C.S.M | SUBWOOFER | – + | |
| SFC | LEVEL |
| |||
| S.SRND | PL | CH SELECT |
| ||
|
| C.FOCUS | TEST |
| ||
|
| FM MODE | ZOOM | GROUP | AUDIO |
|
| FM MODE | SETUP |
| |||
|
|
|
|
|
| |
Radio | Manual tuning |
|
|
|
| |
|
|
|
|
| ||
1 Press [TUNER/BAND] to select “FM” or “AM”.
2 Press [t] or [y] to select the frequency of the required station.
TUNED: Displayed when a radio station
is tuned. | TUNED ST |
| |
ST: Displayed when a stereo FM |
|
broadcast is being received. |
|
Press and hold [t] or [y] until the frequency starts scrolling to start automatic tuning. Tuning stops when a station is found.
3 Adjust the volume.
■If noise is excessive in FM
Press [FM MODE] to display “MONO”.
MONO
Press [FM MODE] again to cancel the mode.
The mode is also canceled when you changed the frequency.
■FM frequency step
The step is
1Press [TUNER/BAND] to select “FM”.
2Press and hold [TUNER/BAND].
After a few seconds the display changes to show the current minimum frequency. Continue to hold the button down. The minimum frequency changes and the step is changed.
To return to the original step, repeat the above steps.
Note
Any FM frequencies preset in channels will be changed by this procedure. Preset them again.
■When you receive poor AM radio reception
RQT6945 Turn off the television if it is too close to the unit.
Preset tuning
Preset channels to make selection simple.
Up to 15 stations can each be set in the FM and AM bands.
Automatic presetting
1 Tune to “FM 87.9 MHz” or “FM 87.5 MHz” (\ left).
2 Press and hold [ENTER].
Release the button when “FM AUTO” is displayed.
The tuner presets all the stations it can receive into the channels in ascending order.
“SET OK” is displayed when the stations are set. The last station to be set is then played.
3 Tune to “AM 520 kHz”.
4 Press and hold [ENTER].
■“ERROR” is displayed
Presetting was unsuccessful. Preset manually.
Manual presetting
1 Tune to the station (\ left).
2 Press [ENTER].
3 While “PGM” is flashing
Press the numbered buttons to select a channel.
Alternatively, press [u, 2 CH] or [i, CH 1] then press [ENTER].
CH 1
PGM
The station occupying a channel is erased if another station is preset in that channel.
Selecting channels
1 Press [TUNER/BAND] to select “FM” or “AM”.
2 Press the numbered buttons or [u, 2 CH] or [i, CH 1] to select the channel.
CH 2
PGM
To select a 2-digit number
Example: To select channel 12, press [=>10] \[1] \[2].
24