OPTIONS / ACCESSORIES
CABLE PLUGS
K852-70 - Cable Plug Kit for 1/0-2/0 cable. Attaches to welding cable to provide quick disconnect from machine.
K852-95 - Cable Plug Kit for 2.0-3/0 cable.
NOTE: Two K852-70 plugs are included with the
V250-S.
REMOTE CONTROLS
K857 - Remote Output Control for stick welding.
K963 - Hand Amptroltm for TIG welding. When the V250-S’s Output Control is in the “Remote” position, the hand Amptrol energizes the output and controls the output remotely. The Hand Amptrol connects directly to the 6 pin Amphenol.
Note: When used with the V250-S, the grounding strap on the connector end of K963 must be discon- nected to avoid electrical noise problems. Details are listed under REMOTE CONTROL RECEPTACLE in INSTALLATION section in this manual.
K870 - Foot Amptroltm for TIG welding. When the V250-S’s Output Control is in the “REMOTE” position, the foot Amptrol energizes the output and controls the output remotely. The Hand Amptrol connects directly to the 6 pin Amphenol.
K814 - Arc Start Switch. Energizes the output for TIG welding if remote output control of the amperage is not desired. When using the Arc Start Switch set the Output Control to the “LOCAL” position.
INVERTEC V250-S