Friedrich US14C30, US12C30, US12C10, US10C30, US10C10, US08C10 manual Contents

www.sylvane.com 1-800-934-9194

CONTENTS

1. PREFACE
1.1 SAFETY PRECAUTIONS	2
1.2 INSULATION RESISTANCE TEST	2
1.3 SPECIFICATIONS	3~8
1.4 FEATURES	9
1.5 CONTROL LOCATIONS	9
2. DISASSEMBLY INSTRUCTIONS
2.1 MECHANICAL PARTS	10
2.1.1 FRONT GRILLE	10
2.1.2 CABINET	10
2.1.3 CONTROL BOX	10
2.2 AIR HANDLING PARTS	11
2.2.1 ORIFICE, HEATER ASSY AND TURBO FAN	11
2.2.2 FAN	11
2.2.3 SHROUD	12
2.3 ELECTRICAL PARTS	12
2.3.1 MOTOR	12
2.3.2 COMPRESSOR	12
2.3.3 CAPACITOR	12
2.3.4 POWER CORD	13
2.3.5 THERMISTOR	13

2.4 REFRIGERATION CYCLE	14
2.4.1 CONDENSER	14
2.4.2 EVAPORATOR	14
2.4.3 CAPILLARY TUBE	14
3. TROUBLESHOOTING GUIDE
3.1 OUTSIDE DIMENSIONS	17
3.2 PIPING SYSTEM	17
3.3 TROUBLESHOOTING GUIDE	18
4. SCHEMATIC DIAGRAM
4.1 CIRCUIT DIAGRAM	23
5. EXPLODED VIEW	24
6. REPLACEMENT PARTS LIST	25~30

1. PREFACE

This SERVICE MANUAL provides various service information, including the mechanical and electrical parts etc. This room air conditioner was manufactured and assembled under a strict quality control system. The refrigerant is charged at the factory. Be sure to read the safety precautions prior to servicing the unit.

1.1 SAFETY PRECAUTIONS

1.When servicing the unit, turn off the air conditioner and unplug the power cord.

2.Observe the original lead dress.

If a short circuit is found, replace all parts which have been overheated or damaged by the short circuit.

3.After servicing the unit, make an insulation resistance test to protect the customer from being exposed to shock hazards.

1.2 INSULATION RESISTANCE TEST

1.Unplug the power cord and connect a jumper between 2 pins (black and white).

2.The grounding conductor (green or green & yellow) is to be open.

3.Measure the resistance value with an ohm meter between the jumpered lead and each exposed metallic part on the equipment.

4.The value should be over 1MΩ .

—2—