10
Adjustments
Table Adjustment
The table can be raised or lowered to accommodate the height of the component being drilled (refer to Figure 4). To raise or lower the table, loosen the lock handle. Then use the hand crank to move the table to the desired height. Then retighten the lock handle.
Figure 4. Table Adjustment
Head Adjustment
WARNING: CHANGE THE RADIAL POSITION OF THE DRILL HEAD ONLY IF THE DRILL PRESS BASE IS SECURED TO THE FLOOR. SWINGING THE DRILL HEAD WITHOUT THE BASE BEING SECURED TO THE FLOOR WILL CAUSE THE DRILL PRESS TO BECOME UNSTABLE AND TIP OVER RESULTING IN INJURY AND/OR DAMAGE TO THE MACHINE.
The radial position of the drill head can be changed
Table lock (handle on opposite side)
Table height adjustment
Work table
to accommodate the drilling of a hole that may be offset from the center of the table. Reposition the drill head by loosening the locking handles and swinging the drill head to the desired position. Then retighten the locking handles.
Wiring Diagrams
Refer to Figure 5 for wiring information. The drive motor is115/230 volt single phase or 220/440 volt three phase. Notice: When converting machine voltage, it is necessarry to
|
|
| Green |
| |
Motor |
| Switch |
| Line | |
|
|
|
| ||
|
|
|
| White | |
|
|
|
| Black | |
1 Phase 115/230 Volts |
|
| |||
Motor |
| Green |
| ||
| Switch |
|
| ||
|
|
|
|
| |
|
|
|
| Line | |
| 3 Phase 220/440 Volts |
|
| ||
1 phase Motor Connection |
|
| |||
3 phase Motor Connection |
|
| |||
AC Power | Sensor | AC Power | Sensor | ||
0 110 220 24 | - | + | 0 220 440 | - | + |
Volts |
| Input | Volts | Input | |
1 Phase 115/220 | 3 Phase 220/440 | ||||
| LED Display Connection |
|
| ||