OPERATION |
“
RANGE” SWITCH
The “Range” switch is used to select one of four amperage ranges with generous overlap for Stick/TIG welding, or one Wire Feed welding range.
Process | Range Setting | Current Range |
|
|
|
|
|
|
STICK/TIG | 80 Max. | 50 to 80 Amps |
(constant current) | 130 Max. | 70 to 130 Amps |
(4 range settings) | 180 Max. | 110 to 180 Amps |
| 250 Max. | 160 to 250 Amps |
|
|
|
WIRE FEED |
|
|
(constant voltage) | 14 to 22V | Up to 250 Amps |
(2 range setting) | 18 to 28V |
|
|
|
|
|
|
|
CAUTION
Never change the “RANGE” Switch setting while welding. This will damage the switch.
“CONTROL” DIAL
Provides a fine welding current adjustment within the Range Switch settings in the STICK mode and weld- ing voltage control with the Range switch set in the wire feed mode.
POLARITY SWITCH
Provides three selectable welding polarities: AC, DC+ & DC-
6-PIN CONNECTOR
For attaching optional remote control equipment.
LOCAL / REMOTE CONTROL SWITCH
(See Accessory Section For “K” numbers)
The toggle switch on the control panel labeled "LOCAL" and "REMOTE" provides the option of con- trolling the welding output at the control panel or remotely. Remote connections are made at the
For remote control set the switch in the "REMOTE" position.
CAUTION
Never change the Polarity switch setting while welding. This will damage the switch.
RANGER® 250 GXT APPROXIMATE FUEL CONSUMPTION
|
| KOHLER |
|
| 23 H.P. COMMAND |
|
|
|
Low Idle - No Load |
| .40 Gallons/Hour |
2400 RPM |
| (1.50 Liters/Hour) |
High Idle - No Load |
| .77 Gallons/Hour |
3700 RPM |
| (2.91 Liters/Hour) |
AC CC Weld Output |
| 1.27 Gallons/Hour |
250 Amps @ 25 Volts |
| (4.82 Liters/Hour) |
DC CC Weld Output |
| 1.50 Gallons/Hour |
250 Amps @ 25 Volts |
| (5.69 Liters/Hour) |
|
|
|
DC CV Weld Output |
| 1.41 Gallons/Hour |
250 Amps @ 25 Volts |
| (5.33 Liters/Hour) |
Auxiliary Power |
| 1.48 Gallons/Hour) |
10,000 Watts |
| (5.62 Liters/Hour) |
|
|
|
| RANGER® 250 GXT | |