Using myPower
Placing iPod into myPower
Troubleshooting (continued)
Issue | Solution |
To place iPod into myPower, you must first adhere two of the providing sizing pads into the back plate on myPower. Each set of sizing pads is marked to identify the iPod model for which the pads should be used.
Nothing happens when iPod is connected to your computer.
1. Check the cable connection. Unplug the cable at both ends and make |
sure no foreign objects are in the FireWire or USB ports, and then |
plug in the cable. |
2. Ensure that you have installed the software from the iPod CD, and |
that you are using the required computer and software. See the iPod |
To place iPod in myPower:
1.Peel the paper from the appropriate sizing pad and adhere each pad onto one of the circles on the back plate of myPower.
2.Slide iPod down the face of myPower until the iPod Dock Connector is firmly inserted in to the
myPower’s arms will hold iPod in place.
3. To remove iPod, gently slide iPod up the face of myPower.
Adhering the
Sizing Pads
User’s Guide. |
3. If you are connected via that USB port, ensure that the USB port on |
your computer is USB 2.0 and not USB 1.1. USB 1.1 is not supported |
and is significantly slower than the USB 2.0 and FireWire |
connections. |
Limited Warranty
To remove the optional belt clip:
1. Gently push one arm toward the back of myPower. The belt clip and arms will separate from myPower.
2. Unclip the belt clip from the arms, and snap the arms back into place to secure iPod.
Removable Belt Clip
Placing iPod into myPower
The product enclosed herein is warranted to be free of operational defects for a period of one year from the date of purchase. In the event of a defect in operation during the warranty period Tekkeon, Inc. will replace the defective product when the owner returns all product contents. The limited warranty will be considered void if the unit is tampered with, subject to misuse, negligence or accidental damage, has been improperly serviced, or if the security seal is removed. This warranty is limited to replacement only and shall not cover any other damages. Any product returned to Tekkeon, Inc. with no fault found will be returned to the owner at the owner’s expense.
To obtain warranty coverage, please complete and submit the enclosed myPower registration card.
4
USER GUIDE |
| 9 |
|
|
|
|
|
|