REMOVING/ATTACHING Battery Pack, Assembly

REMOVING/ATTACHING BATTERY PACK

REMOVE BATTERY PACK:

1. Press both release buttons on either side of the Cordless Drill to release the battery pack.

When the battery pack requires recharging, a 3-5 hour charge allows the tool to operate at full power. A charging indicator light on the charger will illuminate to show that charging is taking place.

2. Pull battery pack free of Cordless Drill.

ATTACH BATTERY PACK:

1. Align the raised portion of the battery pack with the groove in the battery compartment of the Cordless Drill.

2. Press the battery pack into place. Make sure

RELEASE

the latches are securely fastened. Do not use BUTTON the Cordless Drill if the battery pack is not

seated properly.

CHARGER

CHARGING BATTERY PACK

CHARGE BATTERY PACK:

1. Make sure the trigger on the Cordless Drill is in the “OFF” position and remove the battery

pack from the Cordless Drill.

2. Plug 120V AC Adapter
into household outlet
and into side of battery
charger. Insert battery
pack into battery charger.
When the battery is placed in	BATTERY
the charger, the red LED	BATTERY
indicator light will remain on.	CHARGER
indicator light will remain on.

BATTERY PACK

120V AC

ADAPTER

LED LIGHT

Before using battery charger, please read carefully all instructions and cautionary markings on battery charger, battery pack and product using battery.

The charger will not automatically turn “OFF” when the battery pack is fully charged. The charging indicator light will remain “ON” until the charger is disconnected from the electrical outlet.

Use only the charger which accompanied your product or direct replacement as listed in this manual. Do not substitute any other charger. Use only Alltrade approved chargers with your product.

Do not disassemble charger.

Do not use charger if it has been damaged, left outdoors in the rain, snow, wet or damp environments, or immersed in liquid.

The battery pack and charger heat during charging. Place the charger on a flat, non-flammable surface away from flammable materials with at least four inches of clearance to allow proper air circulation around the charger and battery pack.

3.When fully charged, reattach battery pack onto Cordless Drill, making certain latches fasten securely. Cordless Drill will not operate properly if the battery pack is not seated properly.

ASSEMBLY

Be aware that this tool is always in an operating condition because it does not have to be plugged into an electrical outlet. Always turn the switch “OFF” and remove the battery pack before changing bits.