Kawasaki 840378 To Lock, To Unlock, Safe Operating Positions, Changing the Blade

Page 12
ARBOR SCREW,
WASHER, OUTER
BLADE GUARD.

TO LOCK:

1.Push the handle down as far as possible.

HANDLE LOCK

2. Push in the handle lock.

TO UNLOCK:

1. Push down on the saw handle.

2. Pull out the handle lock.

3. Release the handle and let the saw rise up to the operating position.

OPERATING THE HANDLE LOCK

SAFE OPERATING POSITIONS

Never cut any workpiece that is so small you cannot keep your hands a safe distance from the blade.

Never stand directly behind the Miter Saw. Keep your face and body out of the path of flying debris.

Keep balanced at all times. Do not reach in front of the blade.

Keep workpiece pressed against the fence while cutting. Do not move your hand until after the trigger is released and the blade has stopped spinning.

Before cutting, double-check your proposed cutting path by making a dry run with the power turned off or by checking the blade path with the laser.

Never let long workpieces sag. This could cause the saw to catch and kick back. Long workpieces should be supported by the table extensions or other appropriate means.

Make sure the bevel adjustment knob and the bevel stop are both securely tightened before using the saw.

CHANGING THE BLADE

Carbide-tipped blades are very brittle and can be easily bent or broken. NEVER use a blade that has bent, broken, missing or loose carbide tips. Damaged tips can cause personal injury.

If a saw blade shows signs of wear or damage, replace it immediately. Dull or damaged saw blades are not safe and may cause personal injury.

ALWAYS make sure the saw is unplugged and the blade stopped before changing

blades.

LOWER GUARD

NEVER use a blade larger than 10" in diameter.

TO CHANGE THE BLADE:

1. Make sure the saw is in the up position.

2. Remove the three mounting screws (as indicated by arrows) and remove the lower guard.

3. Push in on the arbor lock to keep the blade from spinning and use the socket wrench (included with the saw) to turn the arbor screw clockwise.

CHANGING THE BLADE

4. Remove the arbor screw, washer, outer blade guard and blade. Leave inner blade guard in place.

5. Clean area thoroughly, removing all dust particles and debris before replacing blade.

SPRING LOADED

PLATE

CHANGING THE BLADE

6. Make sure the new blade is 10" (25.4cm) in diameter.

7. Slide the blade into place, making sure that the arrow on the blade matches the direction of the arrow on the upper blade guard.

21

CHANGING THE BLADE

Page 11 Page 13
Image 12
Page 11 Page 13
Contents AMP 10 Compound Miter SAW Table of Contents General Safety Rules for ALL Electric Power ToolsCongratulations Intended USERecognize Safety SYMBOLS, Words and Labels Important SafeguardsWork Area Electrical Safety Personal SafetyTool USE and Care Service Specific Safety Rules AND/OR SymbolsImportant Safety Rules for Miter Saws Page Symbols Functional Description Symbol Name ExplanationControls and Components Assembly Installing the Dust BAGAttaching Handle Attaching Bevel KnobAttaching the Vise Mounting the SAWLaser Guide Laser Safety Operation Accessible FieldsAligning the Laser To Align the LaserAdjusting the BLADE-TO-FENCE Angle Adjusting the BLADE-TO-BASE AngleAdjusting the Bevel Operating the Handle LockTo Lock To UnlockSafe Operating Positions Changing the BladeMaking a Miter CUT Cutting Bowed MaterialMaking a Bevel CUT Making a Compound CUTWhen Cutting Angles for AN Inside Corner When Cutting Angles for AN Outside CornerMaintenance and Cleaning To Clean Laser UnitSpecifications Year Limited WarrantyCommercial or Rental Purpose Warranty Disclaimers
Top Page Image Contents