ASSEMBLY
To prevent injury and/or property damage, DO NOT plug in the saw if any part is missing or damaged. Make sure all saw parts are present and undamaged before using this Miter Saw.
ATTACHING HANDLE
1.Locate the handle hole in the front of the miter table.
MITER HANDLE 2. | Insert the screw end of the |
| handle into the hole and turn |
| clockwise until the handle is securely |
| tightened. |
3. | To release the miter table from its set |
| position, loosen the handle a quarter turn |
| and press down on the miter handle |
| release. To lock the table into place, |
ATTACHING THE MITER HANDLE | tighten the handle. |
ATTACHING BEVEL KNOB
1. Slip washer over the screw on the bottom of the bevel knob and insert the screw into the hole at the rear of the saw.
2. Turn knob clockwise until tight.
BEVEL KNOB
ATTACHING BEVEL KNOB
INSTALLING THE DUST BAG
1. Squeeze the two tabs on the neck of the dust bag to open the spring clip wide enough to slip the dust bag opening over the rim of the dust port. Make sure the bag is pushed past the locking ridge.
2. Rotate the bag until the zipper is facing down.
3. Release the tabs.
ATTACHING THE DUST BAG
STORING BLADE WRENCH
To keep the blade wrench from | WRENCH |
being misplaced, slide it into | STORAGE SLOT |
the storage slot at the rear of |
|
the saw base. |
|
WRENCH
STORING THE WRENCH
ASSEMBLING TABLE EXTENSIONS
1.Unplug the power cord.
2.Lock the saw handle and the miter table in the down position.
3.Tilt the saw back and fasten it securely in place to make sure that it will not fall forward or tip off the workbench while you are working underneath the base.
4.Slide the adjustable fence bracket onto the arm of the table extension. Screw the wing screw at the bottom of the bracket until the bracket remains firmly in place.
5.Insert the table extension into the first set of holes on the base. Make sure the fence bracket rests on top of the arms.
6.Slip a bar clamp over each arm, screw side out.
13 | 14 |