Kawasaki Band Saw instruction manual Adjusting the Upper Blade, Adjusting the Thrust Bearing

Page 9

1.Remove power to the band saw by turning the switch off and unplugging at the power source.

2.To open the upper housing door, turn the upper housing locking screw to the left and then (pull) the door open.

3.To open the lower housing door, turn the lower housing locking screw to the left and then (pull) the door open.

1.To adjust the height of the upper blade guide loosen the blade guide locking knob and

then adjust the height using the blade guide adjustment knob.

2. Tighten the blade guide locking

1/8"

 

knob to secure the upper blade

 

guide in position.

 

CLOSE

OPEN

ADJUSTING THE UPPER BLADE

The upper blade consists of a thrust bearing that supports the band saw blade from the rear and two guide bearings that provide lateral adjustment. These guide bear- ings need to be adjusted after every band saw change or any tracking adjustment. The upper blade guide protects against unintentional contact with the saw blade.

For the upper blade guide to provide adequate protection against contact with the band saw blade, it must always be set as close as possible against the work piece (maximum distance 1/8 inch).

Always ensure that the saw is switched off and unplugged from the power supply before making any adjustments. Failure to do so can cause electrical shock, injury or death.

ADJUSTING THE THRUST BEARING

The thrust bearing must be adjusted after every band saw blade change or tracking adjustment.

1.Loosen the thrust bearing locking screw with the Allen key supplied.

2. Adjust the bearing position until it is 1/32-inch away from the band saw blade. When the band saw blade is turned by hand, it should not contact the thrust bearing.

3. Tighten the thrust bearing locking screw.

1/32" FROM BLADE

15

16

Image 9
Contents Band SAW Recognize Safety SYMBOLS, Words and Labels Table of ContentsCongratulations Intended USEGeneral Safety Rules for ALL Electric Power Tools Important SafeguardsAdditional Safety Rules for Band Saws Electrical SafetyGrounding Instructions ImmediatelyImportant Safety Rules for Band Saws Symbols Symbol Name ExplanationRing Selector Settings Functional Description Assembly Assembling the TableControls and Components Connecting the Dust Collector Installing the WorklightOpening the Housing Doors Operating the WorklightAdjusting the Thrust Bearing Adjusting the Upper BladeAdjusting the Lower Blade Guide Adjusting the Upper Guide BearingAdjusting the RIP Fence Adjusting the Miter GaugeAdjusting SAW Blade Tension Adjusting the Bevel AngleAdjusting Blade Tracking When tracking properly, tighten the blade tracking nutSetting the Table Square with the Blade Installing the Band SAW BladeLaser Guide Operation Accessible Fields Laser SafetyUsing the Laser Light Operating the LaserCleaning Maintenance and CleaningAccessories Feeding Work Into the SAWYear Limited Warranty SpecificationsOther Consumer DO-IT-YOURSELF DIY Tools Commercial or Rental PurposeLimitation Of Liability