MAINTENANCE
WARNING
Disconnect power before attempting any maintenance or cleaning to reduce the risk of fire, electric shock or damage to persons.
LIGHT BULB REPLACEMENT
Allow at least 5 minutes for light bulbs to cool off before touching bulbs to avoid accidental burning of skin.
Light bulbs need to be replaced when you notice a dark section of the flame or when the clarity and detail of the log exterior disappears. There are two bulbs under the log set which generate the flames and embers.
To open the light bulb area:
1.Remove the trim by turning the retaining fasteners counterclockwise ¼ turn until the trim releases from the firebox using a slotted screwdriver. (FIGURE 1)
2.Hold the glass in place while removing the retaining clip from the upper center of the firebox.
3.Lift glass out and store in a safe place.
FIGURE 7
To replace the bottom light bulbs:
1.Lift up the front edge of the log until it clears the front tabs. Pull out until the rear tab clears the back ledge, then lift out.
2.Examine the bulbs to determine which bulbs require replacement.
3.Hold the socket while unscrewing the bulb
4.Hold the socket while screwing in the new bulb.
5.Replace the log emberbed by placing the back lip of the log emberbed under the mirror then push the front of the log emberbed down into the recess.
9