Tekkeon MP3700 manual Charging with a Solar Panel, Slide the ON/OFF switch to OFF

Page 7

1.Slide the ON/OFF switch to OFF.

2.Connect the laptop power adapter to the DC IN jack on MP3700. If your power adapter tip does not fit the DC IN jack, connect the input adapter tip that fits your laptop power adapter to the plug on the laptop power adapter, and

plug the other end into the DC IN jack on the end of MP3700.

3.Plug the power adapter into a wall outlet. The red charging indicator will turn on to indicate the battery is charging and is less than 80% charged.

4.When the charging indicator turns to green, press the Capacity Display button to view the battery capacity. If the capacity does not indicate full (all green LEDs on), continue to charge the battery until the battery capacity indicates full.

NOTE: myPower ALL Plus will automatically shut down the power input when fully charged, so you can charge it overnight.

Charging with a Solar Panel

You can charge myPower ALL Plus using a compatible solar panel. The solar panel can connect to the DC IN port, or the 3-Pin Input Port, depending upon the type of solar panel. The DC IN port is designed for use with a DC power adapter with constant current input. Charging myPower ALL Plus efficiently requires a minimum of 1A current output from the solar panel. In general, a 25W or higher

solar panel should provide sufficient power to charge myPower ALL Plus.

The 3-Pin Input port is designed to allow charging by smaller solar panels (lower than 25W), and requires an optional Smart 3-Pin Adapter available from Tekkeon. To use the solar panel with this port, the solar panel must have a minimum open circuit voltage of 15V. However, there is no minimum output current requirement from the solar panel.

USER GUIDE

5

Image 7
Contents MP3700/MP3450-10 User Guide Page User Guide Overview Unpacking myPower ALL PlusGetting Started Storing myPower ALL Plus Getting to Know myPower ALL PlusCharging with a Laptop Power Adapter Charging myPower ALL PlusCharging with a Solar Panel Slide the ON/OFF switch to OFFTo Charge through the DC in Port Select/Connect the Adapter Tip Using myPower ALL PlusConnect the Portable Device Connect the Power Output CordConnect the 5V Device Using the Device USB Cable Connect the 5V Device Using an AdapterCapacity Indicator View myPower ALL Plus Battery CapacityModel No Marking AdaptersSample markings for each type of adapter are shown here PA-CLA AccessoriesAdding the Extended Battery Using the Extended Battery MP3450-10Charging the Extended Battery Center Positive Symbol Center Negative TroubleshootingDisclaimer of Warranties Limited WarrantyCustomer Support Cut loose. Stay loose