Adding a Lubricator Accessory, Refill Lubricator

Adding a Lubricator (Accessory)

To add an accessory air line lubricator to the kit, you must order Part No. 244841 Lubricator Accessory Kit.

1.Remove filter/regulator from mount bracket.

2.Remove the pin (B) from the outlet of the filter/regu- lator. FIG. 2.

3.Remove regulator cover.

4.Slide the threaded end insert off (13)with outlet fit- tings still attached.

5.Install the modular connector (2a) (with o-rings and grease provided) between the filter/regulator and the lubricator (L).

6.Install the threaded end insert (13) onto the outlet of the lubricator (L) with o-ring and grease.

7.Install the three retaining pins (B).

NOTE: On light weight cart units only, replace the 3/4” npt pipe extension and the 3/4” npt f x f elbow with the 3/4” npt f x m elbow supplied with kit 244841, refer to instructions (form 406512) included with kit.

Installation

1	B	B
1

r_24e025_3A0293_4a

FIG. 2

The lubricator meters oil into the moving air stream to automatically lubricate air-operated motors. A manual adjustment in the housing (F), Fig. 2, sets the oil drip rate into the air stream, which can be monitored through a sight glass. One to two drops of oil per minute is com- mon. Use an oil rated at 50 to 200 SUS (ISO grade 7 to

46)at 100°F (38°C), such as Graco motor oil, Part No. 202659.

Refill Lubricator

1.Unscrew the fill plug (L, FIG. 2) and pour in the oil. The lubricator’s capacity is 7 oz. (0.2 liter).

2.Check the oil level with the side sight glass. The lubricator can be refilled with the system pressur- ized. However, always relieve the system pres- sure before removing the bowl for any reason.

3A0293C