ASSEMBLY AND ADJUSTMENT
ESTIMATED ASSEMBLY TIME 35~50MINUTES
ASSEMBLY INSTRUCTIONS
Philips screwdriver | Combination square |
Adjustable wrench | Straight edge |
|
Feeler gauge - size 0.02
WARNING
For your safety, never connect plug to power source receptacle until all assembly and adjustment steps are completed, and you have read and understood the safety and operating instructions.
LEG STAND ASSEMBLY (Fig. A)
1.Lay the top plate (1) upside down on a flat surface.
2.Attach a leg (2) to the outside of the stand top plate with four carriage bolts (3), washers (4), and nuts(5). Do not tighten.
3.Repeat for the remaining three legs.
4.Attach two long brackets (6) and two short brackets (7) to the inside for the legs, using carriage bolts (3), washers (4), and nuts (5). Do not tighten.
5.Place the leg pads (8) on each leg and turn the leg stand upright on a firm level surface.
6.Adjust the stand for stability.
Fig. A | 11 |
| 12 |
1 |
|
5 4 | 3 |
|
2
7
6
WARNING
Although compact, this saw is heavy. To avoid back injury, get help to lift the saw.
ASSEMBLE BAND SAW TO LEG STAND (Fig. B)
1.Lift the saw body (1) and place on the leg stand (2), aligning the mounting holes (3) of the saw base with the four mounting holes of the leg stand top plate.
2.Attach the band saw to the stand with four long hex head bolts (4) and four flat washers (5).
3.Place a flat washer (5) and hex nut (6) on each bolt from the underside. Hand tighten.
4.Tighten all mounting bolts and nuts with a wrench.
5.Tighten all leg stand bolts and nuts with a wrench.
Fig. B
1
4
5
3
2
5
6
THE SAWDUST PORT (Fig. C)
The sawdust port has a
1.Remove the bolts (1) and washers (2) from the sawdust port (3).
2.Open the wheel cover (4).
3.Attach the sawdust port to the edge of the wheel cover, using the same hex. head bolts and washers.
4.Tighten the bolts and close the cover.
8
— 11 —