Hitachi CB 13F instruction manual Fig. C

Page 12

Fig. C	4
	3

1

2

ASSEMBLE THE BAND SAW TABLE (Fig. D, E, F)

Mounting the trunnion support bracket (Fig. D)

1.Remove the two hex head bolts (1) and washers (2), located on the lower band saw housing.

2.Place the trunnion support bracket (3) on the saw body, as shown, aligning the mounting holes.

3.Place the washers on the hex head bolts, and insert into the threaded holes, through the bracket and saw body. Tighten.

4.Thread a nut (4) onto the table stop bolt (5) and screw bolts into the rear tab (6) on the trunnion support bracket.

5.Tighten the nut down onto the bracket tab.

Fig. D	5
	4

1

2

6

3

6.Turn the table right side up.

7.Remove the table insert (13) from the table.

8.Guide the table slot (14) over the saw table and rotates 1/4 turn, so the slot is perpendicular to the blade.

9.Placing the scale lock knob bolts (10) through the trunnion bracket holes (15) as shown, lower the table onto the trunnion bracket.

Fig. E

1314

10

15

13.Place a lock knob (16) on each scale knob bolt adjust the table by aligning the zero scale mark to the scale pointer (17), and tighten the knob.

14.Replace the table insert (13), aligning the indents.

15.Place the table aligning pin (18) in the hole at the front of the table, and tighten.

Fig. F

1318

17

16

— 12 —

Image 12

Contents CB 13F Hitachi Authorized Service Centers Product Specifications NET WeightMotor Drive BeltSafety General Safety InstructionsBefore Using the Band SAW Specific Safety Instructions for Band Saws USE only the Recommended AccessoriesPower Supply and Motor Specifications Electrical RequirementsFig. a Guidelines for Extension CordsAccessories and Attachments Carton ContentsUnpacking Your Band SAW Know Your Band SAW Glossary of Terms Band SAW TermsWoodworking Terms Assembly and Adjustment Assembly InstructionsEstimated Assembly Time 35~50MINUTES Fig. C Installing and Removing the BLADEFig.G RemovingMiter Gauge Fig. H Install Power Bcord Brackets Fig Adjustment InstructionsTable Adjustments Fig. J, K Tilting the table Fig. J Adjusting the 90 Table Stop Fig. KUpper Blade Guide Assembly FIG. N Blade TENSIONFIG. LBlade Tracking FIG. M Upper Balde Guides and Blade Support Bearing Fig. O, P Blade guides Fig. OLower Blade Guides and Support Bearing Blade guides Fig. QOperation Basic SAW OperationsCutting Curves Circle Cutting Fig. UBlade Selection FIG Changing Speed Setting Fig Blade Speed Selection Fig. WRecommended Speeds Speed Application BladetypeMaintenance To Install a NEW Belt Fig. YBand SAW Blade Wheel TiresTroubleshooting Guide Problem Probable Cause RemedyGeneral CuttingProblem Probable Remedy MotorParts List Parts List for Schematic aBand SAW Description Size QtySchematic a Parts List for Schematic B Description SizeSchematic B Band SAW Model NO. CB13FParts List for Stand StandHitachi Koki Canada Co