MOTOR
PROBLEM | PROBABLE | REMEDY | ||
|
|
|
| |
Noisy operation. | 1. Incorrect belt tension. | 1. | Adjust tension. See ASSEMBLY AND | |
|
|
|
| ADJUSTMENTS section INSTALL THE BELT. |
| 2. | Loose motor pulley. | 2. | Readjust and tighten motor pulley set screw. |
| 3. | Loose pulley cover. | 3. | Readjust and tighten pulley cover |
|
|
|
| mounting screws. |
|
|
|
| |
Motor will not start. | 1. Not plugged into power outlet. | 1. | Plug it into the power outlet. | |
| 2. | Switch and key not in ON position. | 2. | Insert key and turn the switch ON. |
| 3. | Motor cord cut or abraded. | 3. | Take to your Service Center for new cord. |
| 4. | Plug on cord is faulty. | 4. | Take to your Service Center for new plug. |
| 5. | Fuse on circuit breaks open. | 5. | |
|
|
|
| line. |
| 6. | Faulty motor. | 6. | Take to your Service Center for repair or |
|
|
|
| replacement. |
|
|
|
| |
Motor | 1. Too many electrical machines. | 1. | Turn off other machines and try again. | |
| 2. | Incorrect fuse. | 2. | Try time delay fuse, or go to circuit with |
|
|
|
| higher rated fuse or circuit breaker. |
| 3. | Wheels do not rotate. | 3. | Unplug and turn wheels by hand, move |
|
|
|
| obstruction. |
| 4. | Undersized extension cord. | 4. | Use correct size extension cord; see page 6. |
| 5. | Short circuit. | 5. | Cord, plug, or motor need repair; take to |
|
|
|
| your Service Center for repair. |
|
|
|
| |
Motor fails to develop | 1. Low line voltage. | 1. | Check power line for proper voltage. | |
full power. | 2. Faulty motor or capacitor. | 2. | Take to your Service Center for | |
|
|
|
| evaluation. |
|
|
|
| |
Motor overheats. | 1. Overload on motor. | 1. | Reduce load to motor, feed work slower | |
|
|
|
| into blade. |
| 2. | Poor ventilation of motor. | 2. | Unplug and clean out around motor; |
|
| Provide better air circulation. |
| provide better air circulation. |
|
|
| 3. | Take to your Service Center for repair. |
|
|
|
| |
Motor stalls or slows | 1. Motor overload. | 1. | Reduce load to motor, feed work slower | |
|
|
|
| into blade. |
| 2. | Low line voltage. | 2. | Check power line for proper voltage. |
| 3. | Loose wire connections. | 3. | Take to your Service Center for repair. |
| 4. | Faulty motor. | 4. | Take to your Service Center for repair. |
|
|
|
| |
Frequent blowing of | 1. Motor overload. | 1. | Reduce load to motor, feed work slower | |
fuses or breaking of |
|
|
| into blade. |
circuit | 2. Overload of electrical circuit. | 2. | Too many electrical appliances on same | |
|
|
|
| circuit. |
| 3. | Incorrect fuse or circuit breaker. | 3. | Have electrician upgrade service to outlet. |
|
|
|
|
|
— 22 —