Operating Instructions
Read the entire Important Safety Information section at the beginning of this manual including all text under subheadings therein before set up or use of this product.
1.Close the Drain (9) completely.
2.Turn the Tool Pressure Regulator
(6) counterclockwise until it is fully closed.
3.Pull the ring on the Safety Valve (3) to check that it operates properly.
4.Attach the Air Hose (20) to the air outlet on the Regulator (6). Connect the other end of the air hose to the air inlet of the tool. Other components, such as a connector and quick cou- pler, will make operation more effi- cient, but are not required.
Note: If inflating tires or other objects, connect the Air Hose (20) to the Infla- tion Chuck (21). Do not overinflate any object.
5.Plug the Power Cord/Plug (7) into the nearest 120 volt, grounded, electrical outlet.
6.Turn the Power Switch (19) to its AUTO or position.
7.Observe the Tank Pressure Gauge (2), and allow the air pressure in the Tank (14) to build up to 70 PSI.
8.Observe the Tool Pressure Gauge (2A), while turning the Tool Pressure Regulator clockwise to increase pres- sure up to the desired level.
WARNING! Do not exceed the tool’s maximum air pressure.
9.The Air Compressor is now ready to use. When finished using the Air
Compressor, turn the Power Switch
(19)to its OFF or O position. Then, unplug the Air Compressor from its electrical outlet.
10.Turn the Tool Pressure Regulator
(6)counterclockwise until it is fully closed.
11.Pull the ring on the Safety Valve (3) to relieve all remaining air pressure in the Tank.
12.Activate the tool in a safe manner to release air pressure from the air hose. Then, disconnect the air hose from the tool, and store the compres- sor in a safe, dry location.
SKU 90168 | For technical questions, please call | Page 10 |