Maintenance And
Servicing
Procedures not specifically explained in this manual must be performed only by a qualified technician.
To prevent serious injury
from accidental operation:
Turn the Power Switch of the compressor to its “OFF” position and unplug the compressor from its electrical outlet before performing any inspection, maintenance, or cleaning procedures.
To prevent serious injury from compressor failure:
Do not use damaged equipment. If abnormal noise or vibration occurs, have the problem corrected before further use.
1.BEFORE EACH USE, inspect the general condition of the Air Compres- sor. Check for loose screws, mis- alignment or binding of moving parts, damaged electrical wiring, Tank, air hoses/accessories (not included), and any other condition that may af- fect its safe operation.
2.AT END OF EACH WORKDAY: Condensation will accumulate inside the Tank (14). To prevent corrosion inside the Tank, the moisture should be drained at the end of each work- day. To drain the moisture, Pull the ring on the Safety Valve (3) to relieve all remaining air pressure in the Tank.
Open the Drain (9) on the bottom of the Tank, and tilt the Tank to allow the moisture to drain. Then, make sure to fully close the Drain.
3.TO CLEAN: Use a clean cloth and mild detergent to clean the body of the Air Compressor. Do not use solvents. Do not immerse any part of the Air Compressor in liquid.
4.
WARNING! If the supply cord of this power tool is damaged, it must be replaced only by a qualified service technician.
SKU 90168 | For technical questions, please call | Page 11 |