Harbor Freight Tools 90168 Recommended Minimum Wire Gauge for Extension Cords

Page 3

ranges and refrigerators. There is an increased risk of electric shock if your body is grounded.

c. Do not expose compressors to rain or wet conditions. Water enter- ing a compressor will increase the risk of electric shock.

d.Do not abuse the cord. Never use the cord for carrying, pulling or unplugging the compressor. Keep cord away from heat, oil, sharp edges or moving parts. Damaged or entangled cords increase the risk of electric shock.

e.If operating a compressor in a damp location is unavoidable, use a Ground Fault Circuit Interrupter (GFCI) protected supply. Use of

a GFCI reduces the risk of electric shock.

RECOMMENDED MINIMUM WIRE GAUGE FOR EXTENSION CORDS

(120 VOLT)

NAMEPLATE

EXTENSION CORD

AMPERES

 

LENGTH

 

(at full load)

25’

50’

100’

150’

0 – 6

18

16

16

14

6.1 – 10

18

16

14

12

10.1 – 12

16

16

14

12

12.1 – 16

14

12

Do not use.

TABLE A

f. USE PROPER EXTENSION CORD. Make sure your extension cord is in good condition. When using an extension cord, be sure to use one heavy enough to carry the current your product will draw. An undersized cord will cause a drop in line voltage resulting in loss of power and over- heating. Table A shows the correct size to use depending on cord length and nameplate ampere rating. If in

doubt, use the next heavier gage. The smaller the gage number, the heavier the cord.

3.Personal safety

a.Stay alert, watch what you are do- ing and use common sense when operating this compressor. Do not use this compressor while you are tired or under the influence of drugs, alcohol or medication. A moment of inattention while operating compressors may result in serious personal injury.

b.Use personal protective equip- ment. Always wear eye protection. Safety equipment such as dust mask, non-skid safety shoes, hard hat, or hearing protection used for appropri- ate conditions will reduce personal injuries.

c.Prevent unintentional starting. Ensure the switch is in the off-po- sition before connecting to power source or moving the compressor.

d.Do not overreach. Keep proper footing and balance at all times.

This enables better control of the compressor in unexpected situations.

e.Dress properly. Do not wear loose clothing or jewelry. Keep your hair, clothing and gloves away from moving parts. Loose clothes, jewelry or long hair can be caught in moving parts.

f. Only use safety equipment that has been approved by an appropri- ate standards agency. Unapproved safety equipment may not provide adequate protection. Eye protection must be ANSI-approved and breath- ing protection must be NIOSH-ap-

SKU 90168

For technical questions, please call 1-800-444-3353.

Page 3

Image 3
Contents Oilless Compressor Save This Manual General Safety WarningsRecommended Minimum Wire Gauge for Extension Cords Air Compressor Safety Warnings For technical questions, please call Grounded Compressors Compressors with Three Prong Plugs Grounding InstructionsUnpacking SpecificationsProduct Overview For technical questions, please call Operating Instructions Maintenance Servicing Please Read the Following Carefully Parts ListAssembly Diagram Limited 1 year / 90 day Warranty