Fig. 3
17.Allow this compressor to cool, then wipe down and replace into the stor- age bag supplied with this unit. (See Fig. 3.) Note: There is also a small storage bag for inflator nozzles that is attached to the Rubber Hose.
18.Store in a dry location.
User-Maintenance
Instructions
Procedures not specifically explained in this manual must be performed only by a qualified technician.
To prevent serious injury
from accidental operation: Turn off the tool, detach the Power supply clamps, safely discharge any residual air pressure in the tool, and release the throttle and/or turn the switch to its off position before performing any inspection, maintenance, or cleaning procedures.
To prevent serious injury from tool failure: Do not use damaged equipment. If abnormal noise, vibration, or leaking air occurs, have the problem corrected before further use.
Cleaning, Maintenance and
Lubrication
Note: These procedures are in addition to the regular checks and maintenance explained as part of the regular op- eration of the Air Compressor.
1.Wipe down the compressor with a clean dry cloth.
2.Check the hoses to be sure there are no cracks or worn areas.
3.Rotate Filter counterclockwise and remove from the compressor. Gently pry the cover from the threaded end.
Remove the filter, wash in warm wa- ter and liquid soap (no harsh powder soap), rinse thoroughly, and let dry
4.Insert back into the filter holder. Align the three indexing ribs on filter hous- ing with the three recessed grooves in the filter cover and push the cover, snapping it onto the housing. Thread the assembly back into the front cov- er, being careful not to cross thread it.
5.Lubricate the Shaft (30) and Piston Ring (31) after using 20 times.
a.Remove four Screws (4) holding the Front Cover (5) in place and slide the Front Cover off. (See Assembly Diagram.)
b.Put a drop or two of machine oil on the Shaft (30) and Piston Ring (31).
REV 10a
SKU 66399 | For technical questions, please call | Page 8 |