Harbor Freight Tools 41453 manual Unpacking, Assembly Instructions

20.MAINTAIN CONTROL OF THE WORKPIECE AT ALL TIMES. Whenever possible, secure the work piece with clamps, in a vise, etcetera.

21.ALWAYS DISCONNECT THE CUTOFF SAW FROM ITS ELECTRICAL SUPPLY SOURCE BEFORE PERFORMING ANY SERVICES OR MAINTENANCE. Unplug the Cut-Off Saw when leaving the work area, moving the tool from one location to another, changing Cut-Off Grinding Wheels, cleaning debris from the tool, etcetera.

22.WARNING: Some dust created by power sanding, sawing, grinding, drilling, and other construction activities, contain chemicals known (to the State of California) to cause cancer, birth defects or other reproductive harm. Some examples of these chemicals are: lead from lead-based paints, crystalline silica from bricks and cement or other masonry products, arsenic and varies, depending on how often you do this type of work. To reduce your exposure to these chemicals; work in a well ventilated area, and work with approved safety equipment, such as those dust masks that are specially designed to filter out microscopic particles. (Califor- nia Health & Safety Code § 25249.5, et seq.)

23.WARNING: People with pacemakers should consult with their physician(s) before using this product. Operation of equipment in close proximity to a heart pacemaker could cause interference or failure of the pacemaker.

UNPACKING

When unpacking, check to make sure all parts listed and shown on pages 10 and 11 are included. If any parts are missing or broken, please call Harbor Freight Tools at the number shown on the cover of this manual as soon as possible.

ASSEMBLY INSTRUCTIONS

For additional references to the parts listed below, refer to pages 10 and 11 of this manual.

To Install A 6” Cut-Off Grinding Wheel:

1.Caution: Prior to installing a Cut-Off Grinding Wheel (not provided), make sure the Cut-Off Saw is disconnected from its electrical power source.

2.Release the Chain (51), and allow the Housing (22, 44) to rest in its full upward position. (See Figure C, and Assy. Diagram.)

SKU 41453 For technical questions, please call 1-800-444-3353. PAGE 6