Harbor Freight Tools 46055 operating instructions Operation

Operation (continued)

Note: Unplug tool before making adjustments.

5.Your Jigsaw can be adjusted from zero degrees to forty-five degrees for miter cuts by loosening the bolt on the bottom of the base with the Hex Spanner (#32). See Figure 4.

Figure 4

Note: After loosening the bolt, tilt the base and use the numbered gradient gauge on the housing

of the saw for an accurate angle. Tighten bolt.

6. By loosening the same bolt as in Figure 4, you can

slide the base back for cutting the front plane of a workpiece. See Figure 5.

7.To plug-cut into a workpiece that hasn’t been pre-drilled, rest the rear of the base on the workpiece with the blade not touching the surface. Start the tool and very slowly lower the blade into the workpiece until the saw sits level. Then move the tool forward to cut. Hold Saw firmly and beware of kickback.

See Figure 6.

Figure 5

Figure 6

SKU 46055 Page 10