Blade Mounting (Continued)
3.The Ball or guide must be positioned before use. See Figure 2.
4.Using the Hex Spanner (#32), loosen the Bolt on the bottom plate. Refer to Figure 2.
5.Slide the positioner so that the Ball is touching the blade. Make sure you are working with a straight blade. Note: If you are cutting synthetic plate or metal, use a little cutting oil between the Blade and the Ball. More on cutting metal on page 11.
Figure 2
Operation
1.Before plugging in Saw, make sure the Switch (#2) operates without sticking. It must spring back to the original position once depressed.
Note: Rotate the Speed Control Switch (#1) from
Note: Make sure your workpiece is securely fastened down.
2.Draw a cutting line on your workpiece.
3.Plug in the Saw and turn it on. Wait until the blade achieves maximum speed.
4.Rest the bottom base of the Saw on the workpiece and move the blade forward. Do not push hard. Let the saw work at its own rate. Do not force the blade. See Figure 3.
Figure 3
Note: Make sure the bottom base is level with the workpiece, or the blade could break.
SKU 46055 | Page 9 |