DeWalt A08184 Maintenance, Before Each Start-Up, How to Start, Customer Responsibilities

Before Each Start-Up:

1.Place On/Auto/Off lever to "OFF".

2.Turn the regulator knob counterclockwise to set the outlet pressure to zero.

3.Attach hose and accessories. NOTE: The hose or accessory will require a quick connect plug if the air outlet is equipped with a quick connect.

Too much air pressure causes a hazardous risk of bursting. Check the manufacturer’s maximum pressure

rating for air tools and accessories. The regulator outlet pressure must never exceed the maximum pressure rating.

How to Start:

1.Turn the On/Auto/Off lever to "ON/AUTO" and allow tank pressure to build. Motor will stop when tank pressure reaches "cut-out" pressure.

2.Turn regulator knob clockwise to increase pressure and stop when desired pressure is reached. The compressor is ready for use.

NOTE: Always operate the air compressor in well-ventilated areas free of gasoline or other combustible vapors. If the compressor is being used to operate a sprayer DO NOT place near the spray area.

MAINTENANCE

Customer Responsibilities

	Before	Daily
	each	or after	Frequently	Yearly
	use	each
		use
Check Safety Valve	●
Drain Tank		●	●1
Air Filter
Air compressor pump intake				●
and exhaust valves
1- more frequent in dusty or humid conditions

Unit cycles automatically when power is on. When performing maintenance, you may be exposed to voltage

sources, compressed air, or moving parts. Personal injuries can occur. Before performing any maintenance or repair, disconnect power source from the compressor and bleed off all air pressure.

A08184 14- ENG