A
Fig. 3 | Fig. 4 |
TO INSTALL GRINDING WHEEL
DISCONNECT TOOL FROM POWER SOURCE.
1.Rest the tool on its back with the spindle facing up.
2.Install and adjust the appropriate wheel guard following instructions in “TO INSTALL WHEEL GUARD” section of this manual.
3.Position the inner flange (A) Fig. 5 on
the spindle (C) with the round hub | C | A | ||||
facing outward, away from tool. |
|
| ||||
Rotate the flange until it drops into |
|
| ||||
place on the spindle. |
|
| ||||
|
|
|
| Use Type 1 Wheel |
|
|
Guard when using Type 1 Wheels. |
|
| ||||
NOTE: For TYPE 1 Blades ONLY: reverse the inner flange and assemble it to the spindle with the round hub facing inward, toward the tool (see A Fig. 6).
Use Type 1 Blade Guard when using Type 1 Blades.
4.Position grinding wheel to spindle.
5. Position outer blade flange to | B |
spindle and thread into place |
|
hand tight. |
|
NOTE: For TYPE 1 wheels, and |
|
for 1/4" thick TYPE 27 wheels, |
|
assemble with the hub side of the |
|
outer blade flange in the wheel |
|
bore (flat side of flange out, away |
|
from wheel), see (B) Fig. 7. |
|
|
|
Fig. 5
A
Fig. 6
Fig. 7
10