Porter-Cable 4212 (29550) instruction manual Cutting the Second Workpiece

Page 22

Step 4 - Reposition the left offset guide (A) Fig. S4 flush against the workpiece (B).

Step 5 - Align the template, using the “tails/Box” template line with the line formed where the scrap board and the workpiece meet.

Step 6 - Mount the straight bit and template guide on the router and set the router bit depth using the “tails/box” bit depth guide.

B

A

S4

S5

Step 7 - Rout between the fingers of the jig with the templet guide against the left side of the fingers, both in and out. This light pressure toward the left will help to prevent loose joints.

Step 8 - Remove the workpiece from the jig.

S6

CUTTING THE SECOND WORKPIECE

NOTE: If the thickness is different between the first and second workpiece, replace the scrap piece in the upper clamp (horizontal Mounting position) with another that is the same thickness as the first workpiece.

Step 1 - Use the T-handle wrench (A) Fig. S8 to loosen the screw on the right offset guide (B) Fig.S10. Move the guide to the far right.

Step 2 - Clamp the first board in the lower clamp on the right side of the jig with the fingers protruding past the template (Fig. S9).Center the protrusions of the wood in between the fingers of the templet.

Step 3 - Move the right offset guide flush against the workpiece and secure it with the T-handle wrench (Fig. S10). Step 4 - Remove the first workpiece.

A

S8

S9

B

S10

22

Page 21 Page 23
Image 22
Page 21 Page 23
Contents Español Página FrançaiseTable of Contents Safety Guidelines Definitions Important Safety InstructionsBackground Information Additional Safety RulesReplacement Parts Dovetail and BOX Joint OverviewThrough Dovetails Dovetail Dado Sliding DovetailProduct Capabilities JIG OverviewCarton Contents Additional Tools Required AssemblyMounting Instructions Clamps OperationTemplate Mounting Template Support Positioning the WoodTearout Reduction HALF-PINS VS. HALF-TAILSAligning the Templates Template Guides Router BIT DepthOptimal Board Widths Board ThicknessBoard Lengths Project LAY OUT DrawersCutting the Tails Items Needed Items Needed for MiniatureCutting the Pins Cutting HALF-BLIND Dovetails Items NeededFitting and Troubleshooting CenterRabbeted HALF-BLIND Dovetails R10 BOX Joints Cutting the First WorkpieceCutting the Second Workpiece Dovetail Dados Sliding Dovetails Cutting the Dado BoardCutting the Tenon Board Maintenance AccessoriesWarranty PORTER-CABLE Limited ONE Year WarrantyCanadian PORTER-CABLE Delta Service Centers Arizona Georgia Minnesota Oregon
Top Page Image Contents