Porter-Cable 698, 697 instruction manual Turn machine on and allow it to come to full speed

Page 13

B AA

DA

C

Fig. 18

Fig. 19

When using piloted bits only part of the edge of the workpiece can be cut since it is necessary to have the other part riding against the pilot.

WARNING: Never leave less than 1… 8" of the workpiece to ride against the pilot. Leaving less than 1… 8" could cause the edge to splinter possibly resulting in serious injury.

Adjust the right hand (in-feed) fence and guard assembly so that the top guard completely covers the cutting area of the installed cutter.

Turn machine ON and allow it to come to full speed.

Place workpiece in first position (see Fig. 20). Using the starting pin as a support, swing workpiece into cutter (second position Fig. 20). When cut is started, press workpiece against piloted bit and swing workpiece away from starting pin. After the cut is started the piloted bit acts as a guide and not the starting pin. Feed workpiece against the direction of rotation of the cutter until complete edge is shaped. Slide workpiece away from cutter and turn machine OFF .

STARTING PIN

1ST POSITION

CUTTING CIRCLE

PILOT W O R K

2ND POSITION

PILOT

CUTTING CIRCLE

STARTING PIN

W O R K

2ND POSITION

3RD POSITION

Fig. 20

13

Page 12 Page 14
Image 13
Page 12 Page 14
Contents Router/Shaper Never Remove Grounding Prong from Power Plug Safety InstructionsGrounding Instructions Extension CordsTechnical Service Manager Porter-Cable Corporation Important Safety InstructionsRead and Follow ALL Instructions Keep Cutters Sharp Additional Safety Rules for ROUTER/SHAPERWhen servicing use only identical replacement parts Replacement PartsTOR Never RUN Stock between fence and cutterAssembling Table Operating InstructionsExtension Cord Selection R E W O R DLeft Leg Right Leg Left Fence Bracket Selecting the BIT Fastening ROUTER/SHAPER to Work BenchAdjusting BIT Exposure Installing and Removing BITPORTER-CABLE / Rockwell Professional Routers NON-PLUNGE RouterPlunge Router Model 7538 or Adjusting the FenceSwitch Lock Connecting to Power SourceStarting and Stopping the Moto R Shaping with Piloted Bits Using the ROUTER/SHAPERTurn machine on and allow it to come to full speed Shaping with Fence CROSS-GRAIN Shaping END ShapingKeep to O L Clean MaintenanceShaping Narrow Material Failure to StartService and Repairs AccessoriesBrush Inspection PORTER-CABLE Limited ONE Year Warranty Delta Service Centers
Top Page Image Contents