Porter-Cable 698, 697 Connecting to Power Source, Starting and Stopping the Moto R, Switch Lock

Page 11

CA

DB

Fig. 14

CONNECTING TO POWER SOURCE

CAUTION: Before connecting to power source ALWAYS MAKE SURE THE SWITCH IS IN THE OFF POSITION and that the power circuit is the same as that shown on the specification plate of the Router/Shaper.

1.Plug the motor cord into the short cord extending from the table switch box.

2. Turn the router motor switch ON motor operation will now be controlled by the switch in the front of the table.

3.With the table switch OFF , connect the long power cord extending from the table switch box to the power source.

STARTING AND STOPPING THE MOTO R

CAUTION: Before starting the motor, make sure work piece and all foreign objects are clear of bit and that guards are in place over bit.

TO START MOTOR Move switch lever (A) Fig. 15 up to the ON position.

A

Fig. 15

TO STOP MOTOR Move switch lever (A) Fig. 15 to the OFF position.

SWITCH LOCK

The switch may be locked in the OFF position by removing the switch key while the switch is in the OFF position.

To lock switch, place switch in OFF position and pull switch key out of switch (see Fig. 16). Check to make sure switch is in OFF position.

CAUTION: DISCONNECT MACHINE FROM POWER SOURCE BEFORE REMOVING SWITCH KEY TO PREVENT ACCIDENTAL STARTING WHILE PULLING SWITCH KEY.

A

Fig. 16

11

Page 10 Page 12
Image 11
Page 10 Page 12
Contents Router/Shaper Extension Cords Safety InstructionsNever Remove Grounding Prong from Power Plug Grounding InstructionsRead and Follow ALL Instructions Important Safety InstructionsTechnical Service Manager Porter-Cable Corporation Keep Cutters Sharp Additional Safety Rules for ROUTER/SHAPERNever RUN Stock between fence and cutter Replacement PartsWhen servicing use only identical replacement parts TORR E W O R D Operating InstructionsAssembling Table Extension Cord SelectionLeft Leg Right Leg Left Fence Bracket Selecting the BIT Fastening ROUTER/SHAPER to Work BenchNON-PLUNGE Router Installing and Removing BITAdjusting BIT Exposure PORTER-CABLE / Rockwell Professional RoutersPlunge Router Model 7538 or Adjusting the FenceStarting and Stopping the Moto R Connecting to Power SourceSwitch Lock Shaping with Piloted Bits Using the ROUTER/SHAPERTurn machine on and allow it to come to full speed Shaping with Fence CROSS-GRAIN Shaping END ShapingFailure to Start MaintenanceKeep to O L Clean Shaping Narrow MaterialBrush Inspection AccessoriesService and Repairs PORTER-CABLE Limited ONE Year Warranty Delta Service Centers
Top Page Image Contents