293741 -
POLISHING TIPS
USE ONLY QUALITY POLISH MADE FOR POWER POLISHING APPLICATION and apply per manufacturer’s instructions.
For best results, thoroughly clean surface to be polished.
When polishing automobiles, wash the car thoroughly to remove dust, dirt and other abrasives that may scratch the finish.
Buffs or pads may become gummed up after a period of use. They may be washed out with soap and water. Shake out as much water as possible and then spin dry on machine. Do this in an area where you will not splatter articles.
MAINTENANCE
KEEP TOOL CLEAN
Periodically blow out all air passages with dry compressed air. All plastic parts should be cleaned with a soft damp cloth. NEVER use solvents to clean plastic parts. They could possibly dissolve or otherwise damage the material.
CAUTION: Wear safety glasses while using compressed air.
FAILURE TO START
Should your tool fail to start, check to make sure the prongs on the cord plug are making good contact in the outlet. Also, check for blown fuses or open circuit breakers in the line.
LUBRICATION
This tool has been lubricated with a sufficient amount of high grade lubricant for the life of the unit under normal operating conditions. No further lubrication is necessary.
BRUSH INSPECTION AND LUBRICATION
For your continued safety and electrical protection, brush inspection and replacement on this tool should ONLY be performed by an AUTHORIZED
At approximately 100 hours of use, take or send your tool to your nearest Authorized
Any loss of power before the above maintenance check may indicate the need for immediate servicing of your tool. DO NOT CONTINUE TO OPERATE TOOL UNDER THIS CONDITION. If proper operating voltage is present, return your tool to the service station for immediate service.
8